Curt Trailer Brake Controller Wiring Adapter Installation - 2009 Dodge Ram Pickup Video

The Furrion RV Stereo #DV3300SBL can be paired to your smartphone by completing the following steps: 1. Activate Bluetooth mode on your mobile device. Then press the Bluetooth button on the front panel of DV3300S to enter pairing mode. 2. When…

For a weight distribution system, there are always exceptions,but in general the systems with only bars and chains do not have sway control. They are adjustable in tension for different weight, but are a little more work. The bar systems whether…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

In order to install a 7-way trailer wiring harness on your 1997 Dodge Ram 1500 you are first going to need a 4-way trailer wiring harness if you do not already have one and for that I recommend the T-One Vehicle Wiring Harness part #118329. This is a…

If your 7-way says 'Mopar' on it, it should be the factory 7-way although it might have been a dealer installed instead of a factory installed option. Only vehicles with the factory installed tow package will have the blue under-dash…

If your 2004 Dodge Ram has the factory 7-Way or 4-Way connector, then there should be a plug located under the driver's side of the vehicle right behind the front wheel well (see attached image). There will be more wires on the hood side of the…

The P3 brake controller, #90195, will go into a sort of sleep mode after it detects no movement for 15 minutes. While it is on it does not draw very much power. What you can do to make sure it goes to sleep is exit the truck after turning it off,…

Yes, it is very possible to install/fit a 7-way trailer connector on a 2004 Dodge Ram 1500. I first recommend looking under the vehicle for a square ten pin connector. This (if present) will be located behind the rear bumper near the spare tire and…

Thank you for sending the photo, it really makes things easier! The connector you show in your photo is not the connector for installing a brake controller. If you look on the firewall behind the emergency brake, you will see a white wiring junction…

Start by plugging in the brake control adapter #3020-P into the OEM harness located under the steering wheel, just to the right of the emergency brake pedal. Then find a place to mount the brake controller. It should be in a position that is easily…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

A 13 inch trailer wheel is likely going to use 1/2 inch lug nuts. The torque spec is the same for a 13 inch wheel whether it is steel or an alloy wheel; 75 to 85 foot pounds. I have included a picture with a handy chart with torque values for you as…