Recommended Spare Tire Winch To Replace Damaged One On 2004 Fleetwood Toy Hauler
Updated 03/11/2021 | Published 03/08/2021
Products Featured in This Question
Question:
I have a 2004 Fleetwood Toy hauler I need a spare tire hoist. The old one is a made by Deuer the crank pin comes out the side in stead of the end like the one shown on your site. Can you help?
asked by: Elwyn G
Helpful Expert Reply:
Even though the crank pin on the spare tire carrier on your 2004 Fleetwood Toy Hauler comes out at a different place than the the Lippert Components Spare Tire Winch with Offset Cable # LC159056 you were looking at, you will still be able to use the # LC159056.
The # LC159056 will bolt to the frame of the trailer and you may need the Replacement Crank Extension for Lippert Spare Tire Winch Assemblies - 35-1/2" # LC1315411 to allow you the extra length to be able to use the Crank Handle # LC119226.
I included videos for each of the products mentioned for you to take a look at.
Product Page this Question was Asked From
Lippert Spare Tire Winch with Offset Cable
- Spare Tire Mount
- Under Chassis Mount
- Bolt-On
- Universal
- Trailer
- Lippert
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: e track backing plates
- Search Results: e~track
- Search Results: trailer tie down anchors
- Video: Let’s Check Out the Roadmaster Hy-Power Diode
- Video: Checking Out the Roadmaster Hy-Power Diode
- Shop: Erickson Horizontal E Track - Zinc Plated Steel - 2,000 lbs - 5' Long - Qty 1
- Q&A: Troubleshooting Lack Of Brake Controller Output With A 2025 Chevy Silverado 3500
- Q&A: Is Diode Needed to Prevent Trailer Battery from Backfeeding to Breakaway System
- Q&A: Diode Recommendation to Prevent Trailer Battery From Backfeeding onto Vehicle Wiring
- Q&A: Troubleshooting Low Voltage Output from Brake Controller
- Shop: Roadmaster Single Park Light Diode
- Shop: etrailer Electric Trailer Brakes - 12" - Left/Right Hand Assemblies - 5,200 lbs to 7,000 lbs
- Shop: Roadmaster Hy-Power Diode - (Qty 1)
- Shop: Replacement Crank Extension for Lippert Spare Tire Winch Assemblies - 35-1/2"
- Shop: Brophy D-Ring Tie Down Anchor - Bolt On - 1/2" Diameter - 2,000 lbs
- Shop: 2-5/16" Hitch Ball - 1-1/4" Diameter x 2-5/8" Long Shank - Raw Finish - 30,000 lbs
- Search Results: 10~56
- Search Results: spare tire winch
- Q&A: Wiring Diagram for the Dometic Replacement Single Zone Thermostat
- Search Results: spare tire mount
- Search Results: bp04~395
- Video: Replacement Crank Handle for Lippert Manual Scissor Jack Review
- Video: Checking Out the Replacement Manual Crank Handle for Lippert 5th Wheel RV Landing Gear
- Video: Replacement Crank Extension for Lippert Spare Tire Winch Assemblies Review
- Q&A: How To Install Lippert Outriggers To Your RV To Install New Pull Out Steps
- Shop: Windshield Wiper Blades
- Q&A: What Is The Difference Between Mount-n-Lock Standard Duty And Heavy Duty Bumpers?
- Article: Trailer Wiring Diagrams
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Choose a Cargo Carrier That Will Clear a Rear Mounted Spare Tire or Bumper