Is Specific Mounting Hardware Required for Pre-Drilled Round Rubber Trailer Bumper

Question

Question:

Do you sell the hardware to install rubber bumper for horse trailer? Also how hard is it for me to cut to size? Thanks

asked by: Sue

1

Helpful Expert Reply:

The Pre-Drilled Round Rubber Trailer Bumper # D2-96 is designed to be used with 5/8" Bolts, which are not included, so you'll just want to source it from your local hardware store. The bolt holes are pre-drilled so you don't have to worry about cutting through the rubber with a drill before mounting.

When it comes to cutting to size, you should be able to cut it fairly quickly using a rotary tool or pair of shears and it shouldn't be too difficult using the right tools.

expert reply by: Erik B

1

Answer 1

The holes in the Redline #D2-96 Pre-Drilled Round Rubber Bumpers are 11-1/2 inches on center. You can see the full dimensions by looking at the photo I've edited for you.

view full answer...

Answer 2

To hook up a trailer jack to a 12 volt battery you need to make the connection from the jack's power wire to the positve post on the battery using a ring terminal, like part #DW05705-1. If you don't already have a battery on the trailer you…

view full answer...

Answer 3

The PS-8 screws should work very well going into either material you mentioned. The threads are coarse enough that they'll get good hold on the aluminum or the rubber. For best results, you'll want to ensure that as many screws as possible go…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Is Specific Mounting Hardware Required for Pre-Drilled Round Rubber Trailer Bumper

Product Page this Question was Asked From

Continue Researching