Dimensions of Spindle # TRU77FR

Question

Question:

Can I get a basic drawing of the dimensions of the TRU77FR trailer spindle?

asked by: Pat

0

Expert Reply:

I attached a picture that has all of the dimensions of the # TRU77FR that you are interested in.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Hi Josh; what you have is a Lippert 3,500 lb axle with an 85-1/2" hub face measurement (length) and 70" spring center measurement. All of our 3,500 lb axles are too long to replace what you have so I would reach out to Lippert or Dexter to…

view full answer...

Answer 2

The answer to your question depends on what is damaged. I recommend taking your wheel off and inspecting the hub and drum assembly along with the spindle and the axle itself. If you don't have any experience with this I would take it to a local…

view full answer...

Answer 3

You have a Lippert 3500 lb axle with 10 inch brake assemblies/hub drums. We can't order custom axles, but we do offer a Dexter #7359765-EB off-the-shelf axle that's very similar, the only difference is that the leaf spring seat center to…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Dimensions of Spindle # TRU77FR

Product Page this Question was Asked From

Continue Researching