Possible Ladder Solution to Replace Ladder that is 108 inches

Question

Question:

I am looking for a RV to replace my bent rear roof ladder. The one you list is 84 1/2 Mine is 108 that I need to replace.

asked by: Tony B

0

Expert Reply:

The tallest RV ladder we have is the Stromberg Carlson part # LA-401BA which is 99-1/2 inches. If having a ladder that would start roughly 9 inches higher than what you have now would work for you this would be a great solution.

expert reply by: Jameson C

0

click to enlarge

Answer 1

For your Parallax 555 model there isn't a converter replacement available. You'd have to replace the entire panel with the part #PD4560K18LS8. It does not come with breakers but in manual all of the required ones are listed from different…

view full answer...

Answer 2

The Stromberg Carlson RV Exterior Ladder part #LA-401BA is our best replacement exterior ladder option for a Tiffin Allegro Red Motorhome. It measures 99-1/2" tall and can be trimmed shorter if needed. That said, there is also an extension for…

view full answer...

Answer 3

We have some great replacement ladder options for a Keystone Cougar Half-Ton like the Stromberg Carlson Exterior RV Ladder part #LA-401BA which is 99-1/2" tall and has a 250 lb weight capacity. That said, this is a universal ladder so there may…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hey Micah! Pacbrake has actually been around for a long time, more than 60 years. We have had customers ask for these air bags in the past, and we've seen them on vehicles coming in. Until now, Firestone has been the go to since their quality is…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

Hey Nelson, so you would need two separate systems since a supplemental braking system can only be used with a towed vehicle and a trailer brake controller can only control trailer brakes. Main difference is a supplemental braking system is designed…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Possible Ladder Solution to Replace Ladder that is 108 inches

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching