Cracked skylights can lead to leaks and water damage if ignored. This 3-pack of 14" x 22" replacements makes it easy to refresh multiple openings, with durable construction that holds up to sun exposure so your RV stays dry and protected.
Features:
Specs:
Remove the old skylight, then clean and prep the roof surface so it's dry and debris-free. For added sealing, apply butyl tape (sold separately) along the skylight flange before setting it in place. Secure it with 1" zinc or stainless steel screws (not included), then seal over the flange edges and fasteners with sealant approved for use with polycarbonate plastic. An install kit and extra sealant are available separately (SR76RR or SR86RR). If you'd like help installing your skylight, check out our Installer Locator to find an installer near you.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hello, neighbors, Steven here with etrailer.com. Folks, today we're looking at our Specialty Recreation Replacement RV Skylight, specifically for a 14 x 22 cutout, or rough opening. And you're gonna get a quantity of three in a nice, clear, polycarbonate construction. So, folks, again, that rough opening needs to be a 14-inch wide by 22-inch long. The actual overall, so from side-to-side, the overall outside is 25 1/2-inches long by 17 1/2-inches wide. And again, it's a clear polycarbonate, nice tough construction.
It's gonna be UV-resistant and also impact-resistant. And again, you're gonna get a quantity of three. And hopefully I can get these on here without 'em falling off, but pretty simple. You can push down on 'em, let me zoom in for that. And, again, they're pretty resilient.
They're gonna take a lot of abuse and not break or damage on you. You're gonna get three of 'em. Again, they are made here in the U.S. of the durable polycarbonate construction that's UV-resistant and also impact-resistant. Now the three pack will make sure you have multiple repairs, or just have an extra skylight on hand if you don't need all three.
They're gonna work in RVs, campers, and enclosed trailers. And the clear plastic, again, will let the sunlight shine right through. Made here in the U.S., you get a nice one-year warranty. Now, there's no hardware included or sealant, but they do have all the cutout holes, or the drilled holes, for installation. And you wanna use a sealant that the manufacturer makes.
Just make sure you don't use a self-leveling sealant with these polycarbonate, because the self-leveling sealants out there have a chemical compound that would damage the polycarbonate. Well, folks, that's gonna wrap it up for our quick look at this quantity of three Specialty Recreation Replacement Skylights clear for a 14 x 22-inch rough opening. I'm Steven, thanks for watching.
Ratings & Reviews
Light went in as well as expected. Size was accurate and it’s held up well.
Great product! Justas described.
Excellent experience as always with etrailer !
Nice solid piece, it feels stronger than the original that's replacing. The Smoke tint will help reduce temperatures in the RV.
Great service!
As described in ad. Same as original
Perfect fit and much stronger than the OEM it replaced
Couldn’t find it even on the camper sit es.
Product as described. Looking forward to installing it.
Overall, these are very good replacement skylights. They're molded very well, and are slightly thicker than the original one on my TT that had cracked and been leaking unbeknownst to me since last year. The only complaint is that they're predrilled, and at least 5 of the holes were too close to screw holes from the
original skylight which I didn't want to reuse. Drilling extra holes with virtually no splitting or spalling wasn't difficult at all, but this left 5 irregularly spaced open holes in the skylight edge that simply ended up being filled when the butyl rubber sealant was being compressed as it was screwed into position. The end result should still be very robust and decent looking after I'm able to apply the selected lap sealant as soon as weather permits, but I could have easily established my own optimal screw hole pattern if there had been no predrilled holes. Still very pleased, though.
So far, so good. Not damaged in transient. Have yet to install skylite and garnish. High quality, looks like they will fit my ‘99 HR Endeavor. Will report more later. Thanx
Really like the skylight fit as describe
This skylight is a high quality replacement. The skylight is made from a much more durable plastic than OEM. It does not come with the tube of caulk that is shown in the picture so just keep that in mind when ordering. I recommend using butyl tape under screw holes and sealing the top with 3 tubes of Lap sealant.
Good quality, fair price,
Perfect fit, sealant was correct amount to cover outer edge surface and more.
Skylight and garnish are great however one tube of the sealant would never even come close to completing the job. This kit should come with 2 tubes of sealant.
This skylight seems a little thinner and flimsy compared to icon brand but fit our old inner skylight perfectly.
Looks pretty decent quality, but for $130 bucks they could have included the mounting screws.
Perfect fit and easy installation. Instructions provided were spot-on. No issues at all. Well done.
Thanks for the fast delivery! The skylight was excellent and fit perfect. I’m
The unit I was shipped was quite badly warped at the corners unfortunately. I decided not to install it on my roof, because I was concerned it would not maintain a good seal, or potentially crack. For example when holding down the screw holes, there was a gap between the plastic skylight and roof surface. Maybe it would have been OK for a year or two, but I didn't want to drill new holes in my roof without confidence that it would survive a long while (5+ years).
Replaced original skylight and fit well. Easy installation
A tree limb fall and shattered my original skylight only three days before a big trip.
Etrailer shipped my replacement to South Carolina in under 48 hours and I was able to have everything replaced and ready to go before my big trip.
THANKS ETRAILER!
This skylight was the only one I could find that would work as a replacement for the factory skylight over the shower of my Lance 2185 trailer. I tried an Icon first but it did not fit with the factory inner dome. Although this skylight is the only replacement that fit, the Icon product was sturdier and thicker. I would have gone with Icon if they had one that fit, but I'm okay with this one, assuming it holds up.
These skylights are good replacements for the original skylights. But the original skylights turned yellow and brittle during their six year life, even though the trailer always has shade when parked. So these new ones will likely only last 5 or 6 years as well. Considering how much work it is to replace them, I probably should have upgraded them to Lexan for greater durabilty.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.