How to Wire Ventline BV0199-03 Replacement Switch
Updated 11/13/2020 | Published 11/12/2020
Products Featured in This Question
Question:
Just wondering where both the black wires go or get connected too. One black wire is connected to the fan Motor and the other black wire came loose and I wanna make sure where it goes before I connect it
asked by: Lorenzo T
0
Expert Reply:
The # BV0199-03 switch is installed inline on the 12-V power source feeding the fan. One lead connects to the motor, the other to a 12-V power source. The switch was typically used on Vanair Powered vents like # VP-543SP, although Ventline used them on a few other older fan models.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Replacement Push-Button Switch for Ventline Trailer Roof Vents
- Accessories and Parts
- RV Vents and Fans
- Roof Vent
- Switches
- Ventline
more information >
Continue Researching
- Q&A: Replacement Option For Atwood OD-5001 Water Heater
- Article: REDARC Tow-Pro Liberty vs Tow-Pro Elite
- Q&A: Parts Needed to Install a Red Arc Brake Controller in a 2023 Toyota Tacoma
- Q&A: Correct Replacement Wall Switch for MaxxAir Vent Fan
- Q&A: How Many Pumps of Grease Should be Put in an Axle
- Q&A: Everchill WD-282FWDC Door Removal Instructions
- Q&A: Replacement 8K Landing Gear Recommendation for Venture Landing Gear
- Q&A: Compatibility of Reese Goose Box With Recessed Gooseneck Ball on Flat Bed Truck
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Replace or Install an RV Roof Vent