Front Axle Suspension Enhancement for 2006 Chevy Express 3500 Chassis Motorhome

Question

Question:

I have a 2006 Winnebago Access 29T. Will this product work on a 3500 Chevy Express chassis? SumoSprings Solo Custom Helper Springs - Front Axle Item # SSF-106-47

asked by: Gary T

0

Expert Reply:

I have a solution for your front axle suspension enhancement on your 2006 Winnebago Access 29T with Chevy Express Chassis. I recommend the Timbren Suspension Enhancement System - Front Axle # TGMFG45 which install directly to the frame, will act as a shock absorber and will also reduce body roll.

The SumoSprings Solo Custom Helper Springs - Front Axle # SSF-106-47 are not a fit for your specific vehicle and chassis.

expert reply by: Jason S

0

Answer 1

Since your 2016 Chevy Express is a 3500 the correct Timbren kit you need is the part #TGMFG45 as the #TGMFK15A fits the 2500 models.

view full answer...

Answer 2

If the load in the cargo area of the van will fluctuate quite a bit, I'd go with an adjustable alternative like the Air Lift #AL57205 air suspension. You can easily tailor the stiffness of the springs to the load you're carrying, rather than…

view full answer...

Answer 3

For the front of your 2009 Chevy Express 1500 I recommend getting the Timbren #TGMFK15A. This will the 2WD, 4WD, and AWD models. We also have the #TGMRG25C available for the rear if you are in need. These will be a very easy bolt on install and will…

view full answer...

Answer 4

When you're adjusting a weight distribution system, you're looking for the system to return the front ride height as close as possible to where it was when unloaded, ideally within an inch or so. If you're at or near that point,…

view full answer...

Answer 5

If your 2011 Chevy Vans are diesel models and cutaway models (service vehicles like ambulances or even RVs) then you can use the SuperCoils, #SSC-14 and it will help in reducing tire wear and wear of other components allowing them to last longer but…

view full answer...

Answer 6

In this application, the springs will be handling the downward force or tongue weight applied to the trailer hitch from the trailer. Since a trailer's tongue weight usually runs 10-15% of the trailer weight, at most that trailer is applying 750…

view full answer...

Answer 7

The SumoSprings Solo Custom Helper Springs part #SS45FR do a great job of absorbing road shock like bouncing and bumps. They could fight the Roadmaster Active Suspension though so I recommend using the lowest setting (thin spacer) on the RAS to start…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 10

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Front Axle Suspension Enhancement for 2006 Chevy Express 3500 Chassis Motorhome

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching