Water Inlet Replacement for 2020 Grand Design Reflection 337 RLS with Nautilus System

Question

Question:

My city water connection has a drip leak front side where water supply connects. Ive read that this is a fairly common defect and most are replacing the cheap white plastic fitting with a brass fitting. Is this the part I need? thanks,

asked by: Blake A

0

Expert Reply:

The RV City Water Inlet w/ Brass Check Valve # 372160-85-A-26A would replace your city water inlet and does use brass fittings like you are wanting so it will not leak.

expert reply by: Jameson C

0

Answer 1

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

view full answer...

Answer 2

Hello Chris, Great question! To be honest, I could not find anything that was listed different so I reached out the manufacturer to get the answer. The difference between the two is one has a check valve and the other is just a pass through. The…

view full answer...

Answer 3

Hello Ed, You would think with how much they charge for the campers they would put some decent parts on them. From what I see the 2022 grand design reflection uses an 1/2" MPT fitting, so you will want the RV City Water Inlet w/ Brass Check…

view full answer...

Answer 4

Normally the SAE number isn't a reliable way to pick out replacement lenses, but we know that the #A32RB is the correct replacement for a lens marked SAE-A-P2-DOT-02 like what you have. For an all new assembly you'd want the part #MC32RB.

view full answer...

Answer 5

Hella Dale. We do have the B&B RV City Water Inlet #BM98RR which can be used to replace the inlet on your Nautilus system. We also have the RV City Water Inlet #372160-85-A-26A which is a different brand, but will still be a suitable replacement…

view full answer...

Answer 6

Hey Kyle. Unless you're driving around with 1,500 lbs of gear in the bed of your 2025 Ford F-250, the Air Lift LoadLifter 5000 Ultimate Air Helper Springs item #AL29DQ are not going to be overloaded. Your 5th wheel hitch and a full tank of fuel…

view full answer...

Answer 7

Hello Art, sure can! The Meyer HomePlow Residential Hydraulic Snowplow #ME33FR weighs approximately 460 lbs. That is the total weight of the entire kit.

view full answer...

Answer 8

Hey Mike! I checked with our contact at B&B Molding and found that the Replacement RV Plastic Check Valve with Clip for B&B Molders City Water Inlet #BM46MR is the correct replacement for your B&B Nautilus #BM43GR. This is the same as the…

view full answer...

Answer 9

Allen, not much at all - it really depends on which HomePlow or WingMan you go with. The Meyer HomePlow #ME28FR comes with a wired auto-angling controller, but it can also run with Meyer’s optional wireless kit if you’d rather skip the cable…

view full answer...

Answer 10

Hey Kyle, welcome back! We do not have a brass check valve city water inlet specifically designed for a B&B Nautilus Control Panel like item #BM54GR. I didn't see on option on B&B's website either. You would need to piece one together…

view full answer...

Answer 11

What I think you are asking is, will you need a slide type hitch for the 2022 Ford F-250 Super Duty with the short bed, 6-3/4' length that has the OEM Prep Package (puck system) when towing a 5th wheel RV. The short answer is no you do not have…

view full answer...

Answer 12

You actually don't need to use a sliding 5th wheel hitch even though your 2024 GMC Sierra 2500 has a short bed. On other brand trucks (like Ram and Ford) the cab sits a bit close to the OEM puck system so you need a slider to prevent the 5th…

view full answer...

Water Inlet Replacement for 2020 Grand Design Reflection 337 RLS with Nautilus System

Product Page this Question was Asked From

Continue Researching