Wall Thickness of Replacement Drop Leg with Foot for etrailer and Ram Square TJD-7000-FT
Updated 11/05/2020 | Published 11/03/2020
Question:
what is the thickness of the square tube wall?
asked by: Harold J
0
Expert Reply:
The wall thickness of the Replacement Drop Leg with Foot for etrailer and Ram Square, Direct Weld Jacks # TJD-7000-FT is approximately 1/8 inch.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Drop Leg with Foot for etrailer and Ram Square, Direct Weld Jacks - 7,000 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Drop Leg
- 2 Inch x 2 Inch Tubing
- etrailer
more information >
Continue Researching
- Search Results: trailer jack footplate
- Shop: Replacement Drop Leg with Foot for etrailer and Ram Square, Direct Weld Jacks - 7,000 lbs
- Shop: Replacement Drop Leg for etrailer and Ram Square Direct Weld Jacks - 3K
- Shop: etrailer Boat Trailer Jack w/ Footplate - Sidewind - Fixed Mount - 29-1/8" Lift - Zinc - 2.5K
- Video: Feature Breakdown: Replacement Foot Assembly for Lippert Components Power Stabilizer Jacks
- Search Results: thule replacement end caps
- Search Results: fuses automotive tools
- Search Results: thermal fuse
- Search Results: hitch end caps
- Search Results: 2 pole connector
- Search Results: trailer tongue scale
- Q&A: Availability Of Square Tube Jack Leg 7,000 lb Rated And 25" Long
- Shop: Replacement Foot Assembly for Lippert Components Power Stabilizer Jacks - Qty 1
- Video: Feature Breakdown: Replacement End Cap for T2 Bike Carriers
- Video: Review of Weigh Safe Aluminum Weigh Safe Slider Only - WS74CR
- Q&A: Recommended Stabilizer Supports For Equipment Trailer That Lifts Back Of Truck Off The Ground
- Shop: Big Truck Big RV Tongue Weight Scale for Trailers - 1,000 lbs - Fixed
- Q&A: Tubing Size and Wall Thickness of Pro Series 5K Square Tube Trailer Jack # PS1400850383
- Q&A: Recommendation for Weld-On Rear Jacks for 2020 Griffin 7 Ton Dump Trailer
- Shop: Butt Connector - PVC - for 16-14g Wire - Qty. 1
- Shop: Pollak Complete Assembly 2-Pole Connector - Flat - 18 Gauge Wire - 12 Volt - 15 Amps - 12"
- Video: etrailer Trailer Jack TJD-7000-FT Review
- Q&A: What are the Dimensions of the Replacement Drop Leg with Foot on # TJD-7000-FT
- Q&A: Replacement Drop Leg and Cap for Fulton Square Jack
- Video: All You Need to Know About the RV Refrigerator Roof Vent Cap and Base
- Q&A: Replacement Trailer Clearance Light with part # AEP2 58-59 Stamped on It
- Video: Replacement Pull Pin for etrailer and Ram Pipe Mount Swivel Jacks Spec Review
- Video: What to Know About the Replacement Drop Leg for Bulldog Square Trailer Jacks