How To Remove Moisture From Inside The Taillight On A 2018 Ford E-Series Cutaway

Question

Question:

Im getting moisture inside the back up lense. What can I do to clear and stop the moisture. The mount appears to be well caulked.

asked by: John E

0

Expert Reply:

If your LED Trailer Tail Light w/ Reflector - Weatherproof - 4 Function - 76 Diodes - Clear/Red Lens
Item # DG52721PB on your 2018 Ford E-Series Cutaway is getting moisture in the reverse light then it is most likely not properly sealed. Allow the inside of the light to dry by either putting it in the sun or using a hairdryer. Start by removing the light from the vehicle. Should not be necessary to disconnect the wiring. Remove the old sealant. Wipe area with alcohol. Check foam pad on the back of the light and make sure it is not damp. If it is then it needs to dry. Once it is completely dry the light can be reinstalled and new sealant can be added around the outer edge with Alpha Systems Non-Sag Sealant 1010 - Low VOC - White - 10.3 oz
Item # AL28KV

expert reply by: Shane H

0

Answer 1

Hello again John; when First Brands took over as the parent company for Bargman they discontinued most of their lights. That includes the direct replacement for the 30-91-010 and 30-91-011. Typically we recommend the the Peterson Trailer Tail Light…

view full answer...

Answer 2

Hey Mike, thanks for reaching out. Your roof thickness is going to make this tricky. That Advent system is really built around a standard roof thickness of 2-1/2" to 5", and at roughly 6-1/4" you’re outside that range. Advent doesn’t…

view full answer...

Answer 3

Hello Carlos, I am sorry, but the Bargman 47-84-610 LED is no longer available. The closest options we have to the Bargman 47-84-610 LED would be the LED Trailer Tail Light w/ Reflector, 4 Function, Weatherproof, 76 Diodes, Clear/Red Lens #DG52721PB,…

view full answer...

Answer 4

Hey Dave, I am sure we have an outdoor faucet replacement that would work great on your 2024 Airstream Globetrotter but I don't have a way to look up exactly what your RV came with. In general all RVs have one of two designs. One like the part…

view full answer...

Answer 5

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 6

The Dexstar Conventional Steel Wheel part #AM20514 that you looked at is a great solution for your requirements. It will easily handle the 110 PSI your load range F tires require. The limiting factor is usually the valve stem. Using the Americana…

view full answer...

Answer 7

Hello Roy, thanks for reaching out. We do have the 225/75-15 tires but nothing G rated. Our highest rating in that size would be the E range tires you have now. So we would not have a good tire upgrade option for you. As far as the blowouts, are you…

view full answer...

How To Remove Moisture From Inside The Taillight On A 2018 Ford E-Series Cutaway

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching