Redarc Tow Pro Liberty Install 2019 Ford Ranger
Updated 09/04/2020 | Published 09/03/2020
Products Featured in This Question
Question:
Will this work with adaptive cruise control on a 2019 Ranger
asked by: Alby A
0
Expert Reply:
Yes it will. According to Redarc, Ranger models equipped with the adaptive cruise control can be difficult to obtain a stop lamp signal from. The stop lamp switch will only get input from the driver, not the adaptive cruise. I'm told that instead of the stop lamp switch, the brake signal should be obtained from the CHMSL, (a/k/a the third brake lamp). Also, a diode like # RED34FR will prevent the brake signal from feeding back into the vehicle wiring.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Redarc Tow-Pro Liberty Brake Controller - Dash Knob - Up to 2 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Plug-In
- Dash-Mounted Knob
- Behind-Dash
- Up to 2 Axles
- Indicator Lights
- Single Trailer Only
- Redarc
more information >
Featured Help Information
Instructions
Continue Researching
- Video: Redarc Tow-Pro Elite Trailer Brake Controller Installation - 2019 Ford Ranger
- Q&A: Install Video for Redarc Tow Pro Elite Ford Ranger
- Q&A: Brake Controller Wiring Location on a 2019 Ford Ranger
- Q&A: Installing Trailer Brake Controller on 2019 Ford Ranger
- Shop: Brake Controller
- Q&A: Best Way to Wire the Redarc Brake Controller on 2020 Ford Ranger Without Tow Package
- Q&A: Troubleshooting Difficulty Calibrating The Redarc Tow-Pro Liberty
- Q&A: Where to Find Stoplight Circuit for Install of Redarc EPDK Diode on 2020 Subaru Outback
- Q&A: Is Encapsulated Power Diode Needed to Install Redarc Tow-Pro Liberty on a 2020 Subaru Forester
- Shop: Redarc Encapsulated Power Diode for Tow-Pro Brake Controllers
- Shop: Vehicle Tow Bar Brake System