Replacement Bearings and Grease Cap for PWC Trailer
Updated 09/04/2020 | Published 09/03/2020
Products Featured in This Question
Question:
i have a jet ski trailer dont know the manufactor but need wheel bearing hub covers note my center of my axle has a grease fitting
asked by: Dominick D
Expert Reply:
Your PWC trailer will almost certainly have a 2K capacity axle. The correct bearing set will depend on the reference numbers on your existing bearings, both inner and outer. You most likely have either a L44643 or L44649 as an inner and outer bearing. Whichever of the two you have, the # RG04-040 would be the correct dust cap for your EZ lube spindle.
If you have the L44643 bearings, the # BK1-100 bearing kit is what you'd need. If you have the L44649 bearings, use # BK1-150.
Product Page this Question was Asked From
Dust Cap for Kodiak Disc Brake Kit
- Trailer Bearings Races Seals Caps
- Caps
- EZ Lube Grease Cap
- 2.72 Inch O.D.
- 2.72 Inch
- 6000 lbs Axle
- 7000 lbs Axle
- 8000 lbs Axle
- Kodiak
more information >
Continue Researching
- Q&A: What is the Difference Between the Dexter 010-036-00 and the Timken TMK98ZR Grease Seals?
- Q&A: What Is The Smallest Available Spindle Nut For 2.5k Axle?
- Q&A: Amp Draw on GE Appliances Deluxe RV AC System
- Q&A: Looking For A Nut Retainer And Hub Cap For A 8k Trailer Axle
- Q&A: Timken Double Lip Grease Seal To Replace Grease Seal # GS-2250DL
- Q&A: Is There a Trailer Wheel with a 5 on 4-1/4 inch Bolt Pattern
- Q&A: Does HydraStar Disc Brake Kit Work With Lippert 7,000 lb Axle
- Article: Trailer Wiring Diagrams
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Anti-Rattle Devices
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)