Replacement Leg for Lippert Level Best 3010 System

Question

Question:

Does the 10,000 lb replacement atlas jack for kwilee level best system replace the level best 3010 jack. Pictures attached. It goes on a 2003 Alfa See Ya Motorhome

asked by: Buddy H

0

Expert Reply:

Yes the Lippert Replacement Atlas Jack for Kwikee Level Best Hydraulic Leveling System # LC359278 is a direct replacement for the jack leg you sent in a picture of.

expert reply by: Jameson C

0

click to enlarge

Crest ).

9/23/2024

im looking for a replacement leg only for kwikee level best 3010

Jameson C.

9/23/2024

@Crest) That leg isn't available anymore except from Lippert directly through a warranty claim apparently.

Answer 1

I checked with SoftStart and they have a diagram for the install of their #SSR54FR on Furrion Chill RV AC units like the #FR58PR that you referenced.

view full answer...

Answer 2

I don't recommend converting a wired home alarm to an RV. The issue is home alarms typically use 120v where you will want the 12v alarm for your RV. I recommend using the Atwood RV Carbon Monoxide and Propane Gas Detector - 12 Volt - White…

view full answer...

Answer 3

To replace your Dometic Duo-Therm 57915.622 you can use one of the following from Advent, depending on the color you want: - White: Advent Air Replacement RV Air Conditioner for Dometic Setup #ACDOM135 - Black: Advent Air Replacement RV Air…

view full answer...

Answer 4

The #LC359281 is for the 17K capacity Kwikee Atlas Level Best jack. It only provides the cylinder itself. For the entire assembly, use #LC359275.

view full answer...

Answer 5

We do offer replacement jack options for the Kwikee Level Best 3000 Hydraulic Leveling System, part #LC359278 for 10,000 lb jacks or part #LC359275 for 17,000 lb jacks. These jacks will work on all four corners. If you don't know which weight…

view full answer...

Answer 6

The only thing I consistently pulled up with part number PBD 877-646-9233 was plastic pop-up vents. Here are the available options for your for a 2006 Forest River grey Wolf TT Toy Hauler : Replacement Exterior Pop-Up Roof Vent-Black Steel Item #9106…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 12

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Replacement Leg for Lippert Level Best 3010 System

Continue Researching