How To Add Disc Brakes to Timbren 3.5K Axle-Less Trailer Suspension System

Question

Question:

wanting to do single axle timbern axless 3500 with disc brake - can you list the item I will need to buy from you to build this trailer?

asked by: Don

0

Expert Reply:

The Timbren Axle-Less Trailer Suspension System part # A35RS545 has a 3,500 lbs capacity and it comes with idler hubs. In order to add disc brakes to this setup you'll need the Kodiak Disc Brake Kit part # K2R35D.

expert reply by: Conner L

0

Answer 1

There isn't a grease fitting on the Lock n Roll setups like the part #336VS501 that you referenced. Greasing it would require manual application in the moving parts. The LMX grease like the part #L11390 is the toughest and most waterproof so that…

view full answer...

Answer 2

Yes, it is possible to add brakes Timren Axel-Less Trailer Suspension System. The Timbren Axle-Less Trailer Suspension System - 4" Lift Spindle w/Flange - Off-Road Tires - 2.2K, #ASR1THDS03, that you were looking at has the brake flange mounted,…

view full answer...

Answer 3

Hello Casey, thanks for reaching out. It sounds like the 2,200 lb Timbren Axle-Less Trailer Suspension #ASR1THDS03 will be sufficient for your build. Even if the GVWR is 1,500 lbs and your water tank is full, you would still be safely under 2,200…

view full answer...

Answer 4

Hey Adam! You can do what you're wanting but not with two of the Timbren Axle-Less Trailer Suspension item #A35RD545E you referenced. You'll need different hubs those won't work with hydraulic brakes. I have listed below all of the parts…

view full answer...

Answer 5

Hi Brett, You could replace your torsion axle with the Timbren Axle-Less Trailer Suspension #ASR3500S06, but you'll first want to confirm your trailer's GVWR and remove the lift spacers. These are rated for 3,500lbs so you'll want to be…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 8

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

How To Add Disc Brakes to Timbren 3.5K Axle-Less Trailer Suspension System

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching