Will Timbren Suspension Enhancement System Increase Payload of 2012 Nissan Titan Pro 4X?

Question

Question:

I have a 2012 Nissan Titan Pro 4X. Will the Timbren TNRTTN help with payload capacity? My truck is rated at 1850 lbs of payload and my truck camper loaded with two passengers will run about 2250 lbs. Just wondering if there is any assist from Timbren system or will I need to add another leaf spring. Thanks.

asked by: Michael L

0

Expert Reply:

Adding suspension enhancement like the Timbren # TNRTTN you referenced does substantially help with load support and reducing sag, however it does not increase the payload capacity of your truck. Your 2012 Nissan Titan Pro 4X will have the same 1850 lbs of payload but the system will assist with stability by reducing squat, reducing body roll, and assisting with shock absorption.

It will assist far better than adding a leaf spring as that will change the ride of your truck when not loaded, where this will only engage as needed and is rated for up to 6,000 lbs. The payload of your truck is based on the box, the frame, the suspension, the axle and other components so this system is rated independently but will be a great support as needed.

expert reply by: Jason S

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 4

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

We have lift kits for trailer that easily add 2 inches to the height of the trailer. For that you'd want the part #RR23QX and you'd be set. I attached a picture that shows how it installs to give you an idea. This would be the easiest…

view full answer...

Answer 8

Hey Kim, thanks for reaching out. The Firestone Ride-Rite Air Bags with Easy Mount Compressor #F24XV do fit your 2020 Ram 2500 with rear coil springs, but the hang-up is the under-bed gooseneck hitch. On your truck, the air bag brackets and the…

view full answer...

Answer 9

Hi Fred! The Firestone Ride-Rite Air Bags w/ Easy Mount Compressor - Wireless Control - Single Path - 5,000 lbs #F24XV will indeed fit your 2025 Ram 2500 with the factory puck system. The only vehicles it won't fit are ones that have the factory…

view full answer...

Answer 10

Hey Kyle. Unless you're driving around with 1,500 lbs of gear in the bed of your 2025 Ford F-250, the Air Lift LoadLifter 5000 Ultimate Air Helper Springs item #AL29DQ are not going to be overloaded. Your 5th wheel hitch and a full tank of fuel…

view full answer...

Answer 11

Hi Kaleb, great question. I know combining air bags with a B and W Turnoverball hitch can be tricky, but there is a good option that works with your setup. With the B and W Turnoverball Hitch part #BWGNRK1108 on your 2002 Ford F250 4x4 long bed. One…

view full answer...

Answer 12

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Will Timbren Suspension Enhancement System Increase Payload of 2012 Nissan Titan Pro 4X?

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching