Gate Valve Mounting Bolt Spacing for Valterra T40A Bladex Waste Valve
Updated 08/05/2020 | Published 08/04/2020
Question:
There are four bolts that attach the gate valve to the housing. The center to center bolt measurements on my existing valve are 3 3/4 inches. What is the center to center measurement on the T40A?
asked by: William B
0
Expert Reply:
The horizontal center to center bolt distance is 3-7/8 inches, with the vertical being 3-3/4 inches as shown in the provided photo. I've linked to a product description for the Valterra waste valve.
expert reply by:
Mike L
0
click to enlarge
Product Page this Question was Asked From
Valterra Bladex Waste Valve for RV Black Water Tank - 3" Spigot to 3" Spigot
- RV Waste Valves
- Straight Valve
- Single Waste Valve
- 3 Inch Valve Body
- Manual
- 3 Inch Spigot
- Stationary Valve
- Valterra
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What is Difference Between RV Waste Valves Hubs and Spigots
- Q&A: How Much Power Does the 3.3 cu ft Norcold RV Mini Fridge w/ Freezer Use?
- Article: How to Winterize & De-Winterize Your RV (Simple Guide)
- Article: How to Replace or Install an RV Roof Vent
- Q&A: Replacement Lid And Operator Kit Recommendation For Ventline Ventadome Roof Vent
- Q&A: What Is The Difference Between A Spigot And A Hub?
- Q&A: What Hitch Receiver do You Recommend for My 2022 Grand Design Imagine 2600RB Travel Trailer?
- Q&A: How to Determine Correct 3" Waste Valve for RV Black Water Tank
- Q&A: Replacement Control Unit For a 1510000172 Kwikee Step Control Unit
- Article: How Level Should a Tow Bar Be When Flat Towing