Will the Curt Trailer Wiring Harness for a 2012 Honda Odyssey Work With Backup Sensors/Camera

Question

Question:

My new to me vehicle, 2012 honda odyssey touring, has backup sensors and camera. Do I need the wiring with the backup sensor connector? Can I use the Curt wiring w/o the backup sensor wiring?

asked by: Brian A

0

Expert Reply:

The Curt T-Connector Vehicle Wiring Harness part # C56378 is a fit for a 2012 Honda Odyssey with or without backup cameras or sensors so you won't have any issues. There isn't a version of this harness for models with or without backup cameras or sensors as they will not be affected.

expert reply by: Conner L

0

Answer 1

For wiring to add a brake controller to your tear trailer when towing with your 2014 Honda Odyssey, the vehicle must first have a 4-way wiring harness. If you need a 4-way, I recommend the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer…

view full answer...

Answer 2

The Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #C56378 has the second white quick connect and wire to give you the backup camera function. It is a through wire to allow that system to function correctly. If you have…

view full answer...

Answer 3

To add a 7-Way connector to your 2016 Honda Odyssey you will need to add two different wiring harnesses. The first harness you will need is the Curt T-Connector Vehicle Wiring Harness item #C56378. This harness is custom fit and plugs into existing…

view full answer...

Answer 4

The primary difference is a matter of numbers. When installed, the Draw-Tite Class III #76025 will sit so the inside top edge of the receiver tube sits about 13 inches above the ground, and the receiver tube will sit under the bumper so that the…

view full answer...

Answer 5

I have exactly what you need to add a 7-way trailer connector to a 2016 Honda Odyssey. For this, you'll need to start with a 4-way trailer connector and I recommend the T-One Vehicle Wiring Harness part #118521 which is plug-n-play. Then you can…

view full answer...

Answer 6

Hi Mike! Do you want a completely hidden hitch or one where only the receiver is visible? The Curt #C64NR you looked at has a concealed cross tube so you will only see the receiver hanging down at the rear. The Hidden Hitch by Draw-Tite #DT76GR will…

view full answer...

Answer 7

For the video on the Curt Class III hitch receiver for 2007 Honda Odyssey, Part #C13068, as you noted we did not happen to include the measurement of the distance from the ground to the top of the installed receiver, as we did for the Draw-Tite…

view full answer...

Answer 8

You can install a stack cooler in your vehicle. The Class ratings are there as a reference point to a hitch Class. For example if someone has a Class III hitch they can look at coolers, see a Class III and say, hey, I have a Class III hitch so this…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Will the Curt Trailer Wiring Harness for a 2012 Honda Odyssey Work With Backup Sensors/Camera

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching