Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The Curt T-Connector Vehicle Wiring Harness part #C56378 is a fit for a 2012 Honda Odyssey with or without backup cameras or sensors so you won't have any issues. There isn't a version of this harness for models with or without backup cameras…
view full answer...A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
view full answer...The heat shield actually has to be permanently removed to install the etrailer Trailer Hitch Receiver #e83ZR on your 2024 Subaru Forester.
view full answer...To wire a 7-Way trailer connector at the rear of your 1994 Chevy pickup, you will need to start with a working 4-way connector, item #118315, if your truck is not already equipped with one. You would then use the 4 Pole to 7 Pole and 4 Pole Adapter,…
view full answer...The best way to add a 7-way trailer connector onto the back of your 2017 Lexus RX 450h that already had a 4-way connector is with #ETBC7. This gives you all the components needed for a fully functioning 7-way and comes with the instructions, which…
view full answer...There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…
view full answer...According to my research, your 92865A-1 hub/drum has a 25580 inner and an 14125A outer bearing and a 8 on 6-1/2 inch lug pattern, as does the AxleTek #AKHD-865-7-2-K hub drum you referenced. The #AKHD-865-7-2-K would be an acceptable replacement for…
view full answer...Since you already have the Tekonsha T-One #118760 wiring installed on your 2022 Honda Pilot we have 2 options for you to add the wiring for a 7-Way connector. You can either use the Universal Wiring Harness #ETBC7 which requires routing some wiring…
view full answer...That is exactly what converter #118158 was designed for. You will not have to use diodes, although you could if you wanted and it wouldn't hurt anything, because there is only one input circuit for each of the wires. The red output wire would go…
view full answer...If your 2016 Mercedes-Benz Sprinter 2500 came with a factory 7-way trailer connector then there should be a green connector located under the driver's seat. This green connector would then be plugged into a Mercedes-Benz speciality harness and…
view full answer...The inside diameter of the Wire Loom, 3/8" Diameter #39035 is 3/8 inch and the outside diameter is 1/2 inch.
view full answer...I went out to the warehouse and pulled a Hopkins Wire Loom, #39035, to take some measurements for you. The 3/8 inch diameter is the inside diameter of the loom. And it is already split the entire 10 foot length of the loom so you would not have to…
view full answer...Related Searches
Filter Your Search
Contact and Help