Is Rubber Bumper Sold With 37210615 Hook and Keeper Door Holder Available Separately?

Question

Question:

hello, is the rubber bumper part available separately? thanks

asked by: Jeff D

0

Expert Reply:

It is! We sell that bumper as part # 37210695. It measures 1 inch in diameter at the base by 2-1/4 inches long as shown in the provided photo.

expert reply by: Mike L

0

click to enlarge

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 6

Sure, I can help with that. I can see why the fitment notes are confusing. For a 2012 Toyota Tundra with the factory tow package and factory 7 way connector, you'll want a brake controller that plugs into the factory brake controller port under…

view full answer...

Answer 7

Hey Dale, thanks for reaching out. For your 2010 Toyota Tundra with the factory tow package, a proportional controller is definitely the way to go for smooth braking on a 2-axle trailer, and a really clean option is the Redarc Tow-Pro Liberty…

view full answer...

Answer 8

Hey Connor, since your 2007 Toyota Tundra comes with a factory 7-way the correct kit to install the Redarc Tow Pro Liberty would be the part #RED82CR which comes with the correct harness that plugs in under the dash of your truck. What are you…

view full answer...

Answer 9

Hello Alfredo, thanks for reaching out. You are on the right track with the 25-1/4" long 4,000 lb leaf spring part #e57SR. That sounds like exactly what you need size and capacity-wise. I wouldn't worry about any excessive bounce with those.…

view full answer...

Answer 10

Hey Steve! I just heard back from Dexter and you have a 3,500 lb axle. For self-adjusting brakes you can use the etrailer Electric Trailer Brakes #AKEBRK-35-SA. If you prefer Dexter brakes then you need the Nev-R-Adjust #23-468-469. For bearings and…

view full answer...

Answer 11

Hey Mark, thanks for reaching out, and good question. Both the Redarc #RED98CR and #RED82CR are correct for your 2022 Toyota 4Runner. The only difference is the #RED82CR comes with the universal mounting panel for the knob, while the #RED98CR does…

view full answer...

Answer 12

Hey Zigman, the Redarc Tow Pro Liberty part #RED98CR that you referenced is the best option for a brake controller for your 2026 Toyota Tundra SR. This is one of the best performing brake controllers out there and it only puts a small knob on the…

view full answer...

Is Rubber Bumper Sold With 37210615 Hook and Keeper Door Holder Available Separately?

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching