Parts Needed to Allow Demco DM72VR to Work With Disc Brakes
Updated 07/12/2020 | Published 07/09/2020
Products Featured in This Question
Question:
I have an older DA-66I believe the same as the new DM72VR. I am looking to update the trailer to disc brakes. Is it possible to change out the master cylinder for the disc brake master cylinder with reverse lockout? Or is replacing the entire actuator necessary? And is the Master Cylinder I would need DM5919 if i can go that route?
asked by: Bryan N
Expert Reply:
Good news! For your # DM72VR, you can replace the drum master cylinder with Replacement Master Cylinder w/ Bypass Electric Lockout for Demco Actuators - Disc Brakes Item # DM5918. It will fit in place of the master cylinder you have and it comes with an electric reverse lockout. You will also need to add the Replacement Solenoid Cover for Demco Hydraulic Brake Actuator - Model DA66B - Qty 1 # DM12267-95 to protect the solenoid after installing it on this particular actuator, but that's the only additional part you would need.
In order to determine which disc brakes you can use with your trailer I would need to know the bolt pattern on your current hubs, the inner and outer bearing size or number your current hubs use, and the capacity of the axle. For example, if your current hubs have a # 25580 inner and # 15123 outer bearing, a 6 on 5-1/2" bolt pattern and the axle capacity is 5200 to 6000-lbs, the Kodiak Disc Brake Kit - 12" Hub/Rotor - 6 on 5-1/2 - Dacromet - 5,200 lbs to 6,000 lbs # K2HR526D would be a good choice.
Product Page this Question was Asked From
Demco Hydraulic Brake Actuator - Drum - Zinc - 2" Ball - 7,000 lbs
- Brake Actuator
- Surge Brake Actuator
- Farm Trailer
- Boat Trailer
- Construction Trailer
- Travel Trailer
- Utility Trailer
- Bolt-On
- 7000 lbs GTW
- 2 Inch Ball Coupler
- 3 Inch Channel Tongue
- Drum Brakes
- No Lockout
- Demco
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Demco Hydraulic Brake Actuator - Drum - Zinc - 2" Ball - 7,000 lbs
- Q&A: Surge Brake Actuator to Replace Atwood 82543
- Q&A: Best Replacement for Atwood 82543 Brake Actuator
- Q&A: Replacement Drum Brake Actuator for a 1995 4 Winns Model 3916 Trailer
- Shop: Replacement Solenoid Cover for Demco Hydraulic Brake Actuator - Model DA66B - Qty 1
- Shop: Front Mount Hitch
- Search Results: inner bearing 25580
- Shop: Easy Grease Trailer Hub and Drum Assembly for 5.2K & 6K Axles - 12" - 6 on 5-1/2 - Pre-Greased
- Shop: Hydraulic Brake Kit - Uni-Servo - Free Backing - Dacromet - 12" - Left/Right Hand - 5.2K to 7K
- Shop: Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Q&A: Recommended Front Mount Hitch and Scooter Carrier for a 2019 Ford F-150
- Q&A: Could Demco Actuator part # DM72VR be Manually Locked Out with Rod
- Q&A: Can Hub and Drums On 1990 Four Winns Boat Trailer Be Reused When Replacing Brakes?
- Shop: Dexter Hydraulic Brake Lines and Fittings for Single-Axle, Torsion-Axle Trailers
- Shop: Kodiak Hydraulic Brake Line Kit - Tandem Axle - 20'
- Q&A: How to Charge a Trailer Battery Through a 7-Way Connector
- Search Results: brake cylinder
- Search Results: drum brake actuator
- Search Results: surge brake actuator
- Search Results: brake actuator
- Shop: Brake Controller
- Search Results: demco da66
- Search Results: free backing drum brakes
- Video: Hands-On with the Reverse Lockout Solenoid for Demco Hydraulic Brake Actuators
- Video: How to Choose a Trailer Brake Controller
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: All About the Demco Hydraulic Brake Actuator-DM72VR
on Brake Actuator
