Can the Aluminum J-Channel Trim for Enclosed Trailers Bend
Updated 07/03/2020 | Published 07/02/2020
Question:
Is this soft j-rail and easily formable
asked by: Tammy B
0
Expert Reply:
The J-Channel Trim for Enclosed Trailer part # 362415-955 is made of aluminium which is a very soft metal so yes it could be bent or conformed to a certain shape if needed. However, if you need to make sharp bends heating the metal prior would be ideal.
expert reply by:
Conner L
0
Product Page this Question was Asked From
J-Channel Trim for Enclosed Trailer - 7/8" Tall x 1/4" Deep - Aluminum - Rounded
- Trailer Trim
- Siding
- Stone Guard
- J-Channel Trim
- Smooth
- 1/4 Inch Deep
- 93-1/2 Inch Long
- Aluminum
- TRC
more information >
Continue Researching
- Shop: J-Channel Trim for Enclosed Trailer - 7/8" Tall x 1/4" Deep - Aluminum - Rounded
- Video: Let’s Check Out the J-Channel Trim for Enclosed Trailer
- Search Results: butyl tape
- Q&A: Can 362415-955 Metal J-Channel Be Bent By Hand for Roofline of 1958 Mercury Camper
- Search Results: j channel
- Shop: 6-Leaf Double-Eye Spring for 4,500-lb Trailer Axles - 26" Long
- Q&A: P&F Products J-Channel Rail PF26FR - What Is The Interior Dimension Of The J-Channel?
- Q&A: Will P&F Products H-Channel Frame for Enclosed Trailers Fit Over 1 inch Channel
- Q&A: Availability of Cushioned Pin Box to Replace Lippert Turning Point
- Q&A: Recommended 1" Wide Aluminum Trim
- Q&A: How to Determine 5 Lug Bolt Pattern of Trailer Wheel
- Q&A: Recommended Replacement Triple Steps for ATC Trailer
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Converting Your RV Water Heater to Tankless
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: How to Repair an RV Roof
- Article: Rust Prevention
- Article: Trailer Tire Sizing
- Article: Performance Chips and Modules