Solution for Northern Breeze RV Roof Vent with Bad Motor

Question

Question:

Need vent fan motor...Ventline, VL801-001, 12vdc, 5.0A. Old motor has 3 mounting flanges. For model V2525, Northern Breeze bathroom vent fan in Jayco 33 ft travel trailer.

asked by: Don

0

Expert Reply:

The motor for the V2525 Northern Breeze fan is unfortunately not available as a replacement part. If the motor is bad then the best solution is to replace the entire vent unit with part # V2094SP-34 which has the 12V fan and a manual lift. You will also need the install kit # 344270KITW which comes with seat and mounting hardware.

expert reply by: Jameson C

0

Answer 1

We can get the replacement you need. The Replacement Fan Blade for Ventline Ventadome Trailer Roof Vents part #BVD0215-00 is the most common replacement and matches the round spline shaft of the motor VD218105A. It's overall diameter is 6"…

view full answer...

Answer 2

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 3

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 4

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 5

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 6

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 7

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Answer 8

Hey Edwin, The Skylight #SR89YR will work perfectly fine with your 1-1/4" thick roof on your 2018 Lance 1575, though they typically will require some trimming to the garnish to fit perfectly. You will want to pick up 2 tubes of self leveling…

view full answer...

Answer 9

Hello Lee, thanks for reaching out. If air won't go in at all it could be a bad/clogged valve. You could also have a major leak somewhere. Have you tried a soap test to see if there are any leaks?

view full answer...

Answer 10

For your Reese Goose Box 5th-Wheel-to-Gooseneck Air Ride Coupler Adapter - Lippert 1621 and 0719 - 20,000 lbs #RP94720 you will need the Air System Service Kit for Reese Goose Box 5th Wheel to Gooseneck Air Ride Coupler Adapter #RP86007 which will…

view full answer...

Answer 11

Hello Marc, thanks for reaching out. The Intelli-Power converter/ charger Model PD9260C can only charge lead acid batteries, it will not work with lithium. That said, we do have a suitable replacement for this that is lithium compatible. For that I…

view full answer...

Solution for Northern Breeze RV Roof Vent with Bad Motor

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching