Recommended Trailer Coupler Lock for Coupler with Lip

Question

Question:

Hello, I need a 2 5/16 hitch lock that will fit around a lip.

asked by: Angela

0

Expert Reply:

The best ball style trailer coupler lock we offer for a trailer with a lip is the Master Lock 1-7/8", 2", and 2-5/16" Trailer Coupler Lock part # 379DAT.

expert reply by: Conner L

0

click to enlarge

Scott A.

8/2/2020

Does not fit Jayco underslung hitches

Answer 1

Thank you for sending the photo! While I have a solution for you, the Blaylock Total-Encasement Coupler Lock, part #BLTL-23 will not work. I is designed to fit Bulldog Collar-Lok style couplers that use a 2-5/16" ball, like #BD028463 for…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A 2012 Chevy Cruze can be flat towed but it has to be a manual transmission model. Automatics would need to be towed on a tow dolly like the part #RM-2050-1. For flat towing you'd first need a base plate kit for the vehicle like the Roadmaster…

view full answer...

Answer 4

Hey, Carl. There isn't one specific lock that would be for that coupler. I tried to find some sort of picture of even a drawing of the coupler to see what style would be best for it but I couldn't find anything out there. What I do know about…

view full answer...

Answer 5

Hey Scott! Your 2026 Ford Ranger may or may not have a brake controller port/plug, even with the tow package. There will be four wires coming out of a large wire harness by the driver side firewall, left of the brake pedal, which can be wired to the…

view full answer...

Answer 6

We do have bushings that are close to the 1-1/4 inch outer diameter, but not precisely. The Two Piece Nylon Bushing - Qty 4 #SP05-080 have a 1-5/16 inch outer diameter so it is very close, being 1/16 of an inch off. They do have the 9/16 inch inner…

view full answer...

Answer 7

The Ford Transit if equipped with the factory tow package would have came with both a trailer hitch and trailer connector and they would both be located directly under the rear bumper so odds are you do not have either because they are not hard to…

view full answer...

Answer 8

Hey Dylan - both M-3 plates measure 81-3/4 inches wide, so you'd need to trim off a little bit. The aluminum one #M348FR would be easier to trim, so I'd pick that over the steel one. The hinge runs the full width so you’ll still get solid…

view full answer...

Answer 9

To check the pins on the vehicle side 7-Way, you can use a circuit tester or the volt meter. The circuit tester will show you if a signal is coming through on the pin you are testing while the volt meter will tell you that and how much voltage is…

view full answer...

Answer 10

Hi Mark; the only jack like that is the Lippert Power Stance Electric Trailer Jack #LC89VR but it exceeds the amount you're looking to spend. If you're fine with one that only runs off of the 7-way then I recommend the etrailer Electric…

view full answer...

Answer 11

Hey Seth, The etrailer Electric Trailer Jack w/ 7-Way - Drop Leg - A-Frame - 18" Lift - 5K #e74GV may work on your 2015 Ford F-250, but there's a high chance that it won't straight out of the box. On 2015 and newer Ford trucks with a…

view full answer...

Recommended Trailer Coupler Lock for Coupler with Lip

Product Page this Question was Asked From

Continue Researching