Parts Needed to Flat Tow a 2008 Jeep Rubicon
Updated 08/07/2012 | Published 08/05/2012
Products Featured in This Question
Question:
I purchased a used roadmaster towing system and what parts do I need to tow a 2008 Jeep 4-door Rubicon
asked by: Brandan
Expert Reply:
Without knowing everything you purchased I can just tell you all the parts you will need to flat-tow your 2008 Jeep Rubicon and you can purchase the missing pieces.
The first thing you will need is a base plate kit for your vehicle. For that I would recommend you get a Roadmaster XL Base Plate Kit # 1429-1 as long as you do not have any aftermarket bumpers, winches or guards.
The RoadMaster Sterling All Terrain Tow Bar # RM-576 that you referenced comes with safety cables, lighting wiring and quick disconnects.
Other than that you will need a wiring solution. Check out the FAQ I attached on picking out a wiring solution.
And finally, most states now require a supplemental braking system on the vehicle being towed. The easiest to install and use is the Roadmaster Even Brake portable proportional braking system, part # RM-9400. This unit activates the brakes on the vehicle being towed in proportion to how much the RV is braking. This is the safest type of braking action, and it reduces wear and tear on the RV and towed vehicle brakes.
You will also want to check the vehicle owners manual for additional information on flat towing the vehicle. Some vehicles require an axle disconnect, drive line disconnect, transmission lube pump, or free wheeling hubs in order to be flat towed.
I did some checking and here is what I found:
-2WD w/auto trans needs transmission lube pump.
-4WD auto with neutral position in the transfer case is flat towable. No neutral in transfer case is considered an AWD vehicle, and requires a trailer. You should confirm this with your owners manual.
Product Page this Question was Asked From
Roadmaster Sterling All-Terrain Tow Bar - Non-Binding - RV Mount - 2" Hitch - 8,000 lbs
- Tow Bar
- Hitch Mount
- Telescoping - Non-Binding
- Aluminum
- 8000 lbs
- Fits Roadmaster Base Plates
- Stores on RV
- Cables Included
- Roadmaster
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Must-Have Flat Towing Components
- Search Results: ceiling vent rv vents and fans
- Search Results: dicor lap sealant
- Search Results: decor self leveling
- Search Results: dicor self leveling
- Shop: Valterra RV Ceiling Vent w/ Dampers and Covered Screws - 5" Diameter - White
- Shop: Valterra RV Ceiling Vent w/ Dampers and Covered Screws - 5" Diameter - Medium White
- Shop: Alpha Systems 1021 Self-Leveling Sealant for RVs - White - 10.3 oz - Qty 1
- Q&A: Can 2016 Kia Soul With Manual Transmission Be Flat Towed
- Q&A: Flat Towing
- Q&A: Base Plates, Tow Bar, Wiring, and Safety Cables to Flat Tow a 1999 GMC Jimmy
- Q&A: Parts Needed to Flat Tow 2020 Jeep Wrangler Unlimited
- Q&A: Parts Needed to Flat Tow a 2011 Jeep Wrangler Unlimited
- Q&A: Recommended Parts to Tow 2020 Jeep Wrangler Unlimited Behind Motorhome
- Q&A: Recommended Complete Flat Tow Set-Up For 2014 Chevy Silverado 1500 4x4
- Video: Jensen Antenna: The Breakdown
- Video: Complete Breakdown of the Jensen Antenna
- Video: The Low-Down on the Valterra RV Ceiling Vent w/ Dampers and Covered Screws
- Video: An In-Depth Look at the Solera RV Slide-Out Awning
- Video: Lippert Solera RV Slide-Out Awning Installation - 2011 Forest River Flagstaff Classic Super Lite Tra
- Shop: Jensen Antenna - Top or Side Mount - Rubber Mast - 6"
- Shop: Jensen Antenna - Top or Side Mount - Rubber Mast
- Article: Trailer Wiring Diagrams
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Search Results: trailer hitch
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Search Results: trailer wiring
on Tow Bar
