Custom Fit Towing Mirrors for 2010 Jeep Wrangler

Question

Question:

Hi, I have a 2010 Jeep wrangler. I need towing mirrors for towing an eight foot wide pontoon boat. I like item # KS3891-2 but would rather like mirrors permanently attached to the jeep instead. Im wondering if you can recommend something. Sincerely,

asked by: Tim L

0

Expert Reply:

We have custom fit tow mirrors that snap onto the mirror housings of your 2010 Jeep Wrangler with the K-Source set part # KS80740. I attached a picture of what these look like installed for you to check out as well.

expert reply by: Jameson C

0

click to enlarge

James M.

8/9/2020

Any information if these mirrors will be produced for the 2020 Jeep Wrangler

Jon G.

8/19/2020

Doesn't look like they've had a towing mirror for a Jeep Wrangler for a number of years now. I'm honestly not sure if they will be coming out with a fit for your 2020 Wrangler unfortunately.

Answer 1

Yes, you can correct the vibration in the K-Source, #KS80800, towing mirrors. if you push in on the bottom of the mirror all the way, you will then be able to see a Phillips head bolt in the gap that is exposed at the top of the mirror. Tightening…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

Hey Tim welcome back! Your ARH15AACBL2 GE AC unit has the old 410a refrigerant in it so the GE Appliances item #GE64FR you were looking at isn't going to work as a replacement. The EPA mandated R32 refrigerant has been used in all new AC's…

view full answer...

Answer 12

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Custom Fit Towing Mirrors for 2010 Jeep Wrangler

Product Page this Question was Asked From

Continue Researching