Recommended Cover For Northern Lite 8-11EX Limited Wet Bath Truck Camper

Question

Question:

I have a nothern lite 8-11EX limited wet bath camper. What is cover do i need?

asked by: john

0

Expert Reply:

It looks like your Northern Lite 8-11EX is 94" tall x 98" wide and 195" long. I recommend the Adco SFS AquaShed Truck Camper Cover part # 290-12264 which is made of a triple layer fabric to reduce pooling from rain which leads to mildew. It also is UV resistant to protect it from dry rot and zippered panels to allow you to enter the camper if you need to. I have attached a photo for your reference.

expert reply by: Heather A

0

Answer 1

The Dometic U1400WH is the same as the Fan-Tastic Vent Ultra Breeze Trailer Roof Vent Cover - 23" x 19.5" x 10.25" - White #FVU1500WH. This will fit and work well for your FV3500 fan. It is worth noting that none of the covers will…

view full answer...

Answer 2

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 3

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 4

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 5

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 6

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 7

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 8

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 9

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 12

Hey David, so EcoHitch does not like to post the install instructions for their hitches like the front hitch part #EH54QR that fits your 2023 Ford F-450 but it does come with a set of detailed instructions. Would you like me to track down a set that…

view full answer...

Recommended Cover For Northern Lite 8-11EX Limited Wet Bath Truck Camper

Product Page this Question was Asked From

Continue Researching