Mini Light Bar Mount Buyers Products Comparability with BackRack Headache Rack

Question

Question:

compatible? Is the mini light bar mount compatible with the backrack cab protector?

asked by: Dave P

0

Expert Reply:

It is possible that the Mini Light Bar Mount for Buyers Products Kabgard Headache Rack part # 33785152 fits the Backrack headache rack. It is designed for the Kabgard headache rack part # 33785104 which has a 1" tall by 2" deep square top cross bar that the mount attaches to with the provided hardware. The Mini Light Bar Mount comes with two sets of bolts. The long bolts are about 3-1/4" long and the shorter bolts are 2-1/4". If you measure the top cross bar of the Backrack and its fits these dimensions then you won't have any issues using the Mini Light Bar mount. I have attached a photo of how it attaches.

expert reply by: Heather A

0

click to enlarge

Andrew

5/12/2020

I am looking to mount this on a tractor with a roll over bar that is 2x2, will this fit?

Chris R.

5/14/2020

I don't think you'll have any problems mounting the Light Bar # 33785152 to the 2" square rollover bar on your tractor. You'll likely need to use the longer bolts that are included.

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

Hey Matt, Furrion typically has 4 wires running to their thermostats and the Chill Cube Thermostat #LC74DX is no exception. The harness you see with the thermostat would plug into the Chill Cube's controller and has 4 wires to extra wire to to…

view full answer...

Answer 5

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 6

Hey Timothy! I’m sorry to hear your etrailer 60x24 Folding Cargo Carrier #e98874 is already starting to show some rust. Living near the ocean is definitely tough on exposed steel, even with a protective powder coat. The Benton MoveHitch 60x24 Cargo…

view full answer...

Answer 7

Hey Greg, we have just what you are looking for with the CE Smith idler hub part #CE13515. This is a pre-greased 3,500 lb axle hub that is galvanized like you are looking for. What trailer is this going on?

view full answer...

Answer 8

Hey Neal! You can use the standard 5/8" Hitch Pin and Clip #e47RV for quicker installation and removal, or the Locking Hitch Pin #e98882 if you want to keep the carrier secured to the vehicle. Either way, you will lose the built-in anti-rattle…

view full answer...

Answer 9

Hello David, We do have them listed already. You will want their part number 80960, which is our part K-Source Snap & Zap Custom Towing Mirrors - Snap On - Driver and Passenger Side #KS53NQ. These will be a great fit for your 2023 Chevrolet…

view full answer...

Answer 10

Hey Doyle, welcome back! The push-button mechanism on the Benton MoveHitch Cargo Carrier #B86VR and #B38VR (with cargo net) is very reliable and has been thoroughly tested. It is actually one of the best features of the MoveHitch since it makes it…

view full answer...

Answer 11

Hey Ryan! I would. The Benton MoveHitch #B86VR is built to stay on the vehicle, so leaving it installed throughout camping season isn't a problem. I'd just keep the moving components clean and it wouldn't hurt to occasionally inspect the…

view full answer...

Answer 12

Hey Mark, the best brake controller for a 2024 Chevrolet Colorado Trail Boss is the Redarc Tow-Pro Liberty item #RED52VR. This is a proportional brake controller that automatically adjusts your trailer's braking based on the deceleration of your…

view full answer...

Mini Light Bar Mount Buyers Products Comparability with BackRack Headache Rack

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching