Lance Camper Wiring Harness Recommendation  

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors…

A junction box/7-way plug kit like Epicord #277-000141 or #HS381-9000 lets you convert the camper to match the 7-way RV blade type connector format. This avoids the extra connection points and potential trouble spots from using separate adapters.…

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

The 6-pole sockets that we carry can only handle up to 12 gauge wire so the only way to really swap away from Lance's proprietary connector would be to treat it like a standard camper and switch to a junction box and 7-way connector like parts…

I attached a picture that shows the instructions we have for the Tie Downs part #HSAB that you referenced. We've haven't seen them be an issue on a 2001 Ford F-150, but if you could get me a picture of what your setup looks like I can see if…

Since the 7-way round pin plug is obsolete, your best bet would be to replace the connector on your camper with the common 7-way blade style connector. You'd remove the existing plug on your slide in camper, and replace it with #A7WCB. You could…

The Optronics 7-Way Connector - Trailer End #A7WCB will handle 8-gauge wires on the positive and negative connectors. If you want the same gauge wire on the vehicle side, I recommend the Hopkins Endurance 7-Way Trailer Connector Socket - Vehicle End…

The older Lance truck bed campers use a proprietary plug and we don't have an adapter for this. We don't carry it but Lance does offer a matching vehicle side trailer connector for this but I recommend just converting the trailer connector on…

I do have a solution, but since Lance has their own plug design there are no adapters that will work, including the #47595. The best option is to replace the lance plug with a standard 7-way blade connector like the #PK12706. This will eliminate the…

The difference in harshness between the Timbren kits part #TFR350SDF and #TFRTT350F would be very noticeable. Especially when unloaded. Your truck is already going to have a rough ride as that is the nature of 1 ton trucks but the 12k Timbren kit…

The Equal-i-zer Weight Distribution System #EQ37120ET that you referenced does come with a 2-5/16 inch hitch ball.

Using an additional extender, like part #HE12, is very different than the rack, like part #K2TMC201, having a lengthy shank. The extenders like part #HE12 are usually made of two different sized pieces of steel that are welded together. The HE12 uses…