Red Blinking Propane Light On Atwood RV Carbon Monoxide and Propane Gas Detector

Question

Question:

Hi! I had a new Atwood COLP alarm installed in my 3 year old trailer, in was told by the RV mainatance shop that the alarm was bad. I had the new one put in 6 months ago and used the trailer with power on maybe a total of 5 days on and off throughout the summer. I also just installed some shelves in a cabinet that I stained. I turned the power on when I went to use it today a week later and the green power light is on but now the red light is flashing by the propane. What does this mean and what should I do. The alarm is brand new!? Thanks

asked by: Amylynn H

0

Expert Reply:

The red blinking light on the Atwood RV Carbon Monoxide and Propane Gas Detector part # AT36681 under the propane heading means that the propane sensor is disabled or faulty. I recommend doing a hard reset of the unit but if that does not work then make sure you are getting at least 9 volts to the unit. If the light still blinks after the rest and ensuing it has proper power then it will need to be replaced.

expert reply by: Conner L

0

Answer 1

On your Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 there is a circle Reset/Test button on the top right hand corner of the unit. Simply pressing this button should reset the detector and silence any alarms assuming there isn't an…

view full answer...

Answer 2

We've seen this issue before on your Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 and the beeping every 40 seconds indicates "a fault has been detected that compromises some detector function." What you need to do is use…

view full answer...

Answer 3

The red blinking light on the light of the Atwood RV Carbon Monoxide and Propane Gas Detector AT36681 typically means that the propane sensor is disabled or faulty. Since you've already tried resetting the unit you'll want to make sure you…

view full answer...

Answer 4

The instructions state the rest/test button of the Atwood RV Carbon Monoxide and Propane Gas Detector - 12 Volt - White #AT36681 is the button on the top right, and you need to press that in and hold it down. If the rest does not work and the red…

view full answer...

Answer 5

The Furrion RV Stereo - Single DIN - HDMI, AUX/USB, Bluetooth, NFC, App Control - 60W - 2 Zone - 12V #DV3300SBL has two indents on the side off the faceplate you can gently pull on to remove it from the unit. If you can get it with your fingers you…

view full answer...

Answer 6

My contact at Atwood advised that the light under the "Propane" label blinking red indicates the propane detector is disabled. The blinking indicates that the sensor is worn out and the unit should be replaced with #AT36681. For reference…

view full answer...

Answer 7

If the Atwood RV Carbon Monoxide and Propane Gas Detector part #AT36681 continues to beep even after a rest then this can be narrowed down to either a leak or faulty detector. If you shut off the gas supply to the trailer entirely and the alarm still…

view full answer...

Answer 8

It sounds like your Atwood RV Carbon Monoxide and Propane Gas Detector part #AT36681 is hooked up properly and is getting power. The code you hear is like you said a fault code in this case because of the audible tone. I recommend replacing it. The…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Red Blinking Propane Light On Atwood RV Carbon Monoxide and Propane Gas Detector

Continue Researching