Installation Of CE Smith V-Wing Bolster Bracket for Pontoon Boat Trailers CE26244G
Updated 07/01/2025 | Published 08/16/2019
Question:
How do these mount to the trailer. Is it a single bolt you have to drill through the cross members or is it a u bolt with a plate? Dont see any clear indication of what kind of hardware is required.
asked by: Mike
Expert Reply:
To install the CE Smith V-Wing Bolster Bracket for Pontoon Boat Trailers part # CE26244G you want to use lag screws and a washer to attach the brackets which you will need to source from a local hardware store according to CE so drilling will be required. They also recommend a bracket be installed at each frame cross member for maximum support. The brackets are best when installed with a 2x6 or 2x8 carpeted bunk boards laid flat.
Product Page this Question was Asked From
CE Smith V-Wing Bolster Bracket for Pontoon Boat Trailers - Galvanized Steel - Qty 1
- Boat Trailer Parts
- Bunks
- Bunk Bracket
- 6 Inch Tall
- 3 Inch Wide
- Galvanized Steel
- 15-1/2 Inch Long
- CE Smith
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How To Know Which Master Cylinder Will Be The Correct Replacement For A Surge Actuator
- Q&A: How To Install Rollers On a Pontoon Boat
- Q&A: How Many Screws Are Included With The Stainless Steel Hex Lag Screw # FA74521?
- Q&A: Would 7-Way Trailer Wiring Circuit Have Amperage Rating for Powering 13 amp Horn
- Q&A: Are All 3,500 lb Axle Hub/Drums Interchangeable
- Q&A: Solution for Transporting Native Titan 10.5 Kayak
- Q&A: How To Replace 18 Foot Long Bunk Boards On a Pontoon Boat Trailer
- Article: How to Raise Your Travel Trailer Height
- Article: What To Look For When Buying Ratchet Straps
Anne
6/27/2025
Do I put brackets on trailer 1st or boards on brackets. Right now I have the brackets on trailer bit putting boards on now is quite challenging, please advise