What Size are the Bolt Holes of the Trailer Coupler # DL13800
Updated 03/07/2012 | Published 03/06/2012
Question:
Hello, I have a seal selection trailer with a 1-7/8 coupler. I want to install this 2inch coupler on it. Can you tell me what size bolt holes this has. Thanks
asked by: Gene
0
Expert Reply:
I went out into our warehouse and measured the bolt holes of the Trailer Coupler # DL13800 that you referenced and found them to be about 1/2 inch space 3 inches on center.
Check out the video I put together that shows taking this measurement. If you zoom in on the measurement of bolt hole centers you can clearly see the 1/2 inch holes.
expert reply by:
Jameson C
0
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: brake pads
- Search Results: trailer brakes
- Video: Review of Demco Brake Actuator - DA86 Trailer Disc Brake Actuator - DM78CV
- Shop: Demco DA86 Brake Actuator for Disc Brakes w/ Lockout, Solenoid, and Cover - 2" Ball - 8,600 lbs
- Article: Trailer Wiring Diagrams
- Shop: Trailer Wiring
- Q&A: Surge Brake Actuating Coupler With Reverse Lockout Boat Launching
- Shop: Brake Controller
- Shop: Kodiak Disc Brake Kit - 10" Rotor - 5 on 4-1/2 - Dacromet - 3,500 lbs
- Shop: Kodiak Disc Brake Kit - 10" Rotor - 5 on 4-1/2 - Dacromet and KodaGuard - 3,500 lbs
- Shop: Titan Zinc-Plated Brake Actuator w/ Electric Lockout - Disc - Multi-Fit Ball - Bolt On - 6,000 lbs
- Shop: Dexter DX7.5L A-60L Surge Brake Actuator w Electric Lockout - Disc - 2" Ball - Primed - 7.5K
- Shop: Kodiak Hydraulic Brake Line Kit - Single Axle - 18'
- Shop: DeeMaxx Disc Brake Kit - 10" Rotor - 5 on 4-1/2 - Stainless Steel - 3,500 lbs
- Search Results: da86
- Video: All You Need to Know About the Kodiak Disc Brakes
- Q&A: Installing Hitch When Holes Do Not Line Up
- Q&A: Solution for Trailer Hitch Install Where Holes Don't Seem to Line Up Properly