Can the Trailer Valet XL Trailer Dolly be Used on Grass

Question

Question:

Can you get turf wheels so it will go on grass? I would be interested in the XL.

asked by: Robert

0

Expert Reply:

The Trailer Valet XL Trailer Dolly with Chain Drive # TVXL2 that you are looking at actually has solid rubber tires that use deep treads so you can use it on tricky surfaces like gravel, dirt, or grass. It is meant for use on pavement or well packed surfaces but the deep tread does help as well. I do recommend using a powered drill and the included drill bit for your application though as traveling through grass will be a bit more difficult.

expert reply by: Jon G

0

J R.

7/6/2020

I have a 22’ boat approx 4500 lbs plus a tandem trailer. Going up a 2 degree incline cement drive. Will the Trailer Valet XL work for this?

Chris R.

7/10/2020

The Trailer Valet XL # TVXL2 can technically work on really small inclines like this, but it'll require a bit of work. Capacity-wise your boat trailer isn't an issue. Just keep in mind you may need to push a bit when going up the cement driveway.

Answer 1

The Trailer Valet XL, part #TVXL2 with 2 inch ball and the #TVXL25 with the 2-5/16 inch ball are meant for use on level surfaces only, they wouldn't work well on the slope you describe.. Actually, I have a much less expensive and easier to use…

view full answer...

Answer 2

Sorry Christopher but the maximum grade for the Trailer Valet Remote-Controlled Trailer Dollies like item #TVRVR9 is 5 degrees. You'll need to use a manual one like the Trailer Valet XL Trailer Dolly with Chain Drive item #TVXL2 for 2" or…

view full answer...

Answer 3

Yes. The only difference between the Trailer Valet XL Trailer Dolly with Chain Drive - 2-5/16" Hitch Ball - 1,000 lbs TW #TVXL25 and the Trailer Valet XL Trailer Dolly with Chain Drive - 2" Hitch Ball - 1,000 lbs TW #TVXL2 is the hitch ball…

view full answer...

Answer 4

I do have an option for you but the Xtreme Off-Road Ratcheting Trailer Jack part #ORJW1SU isn't quite cutout out for what you're wanting. Instead, I recommend the Trailer Valet 5X Swivel Jack and Trailer Mover part #STC-V211 which is rated…

view full answer...

Answer 5

I just checked with Trailer Valet and I have a solution for you but the Trailer Valet 5X item #STC-V211 tops out at 7 degree slopes. For use on your 10 degree driveway you will need the Trailer Valet XL Trailer Dolly with Chain Drive item #TVXL2. The…

view full answer...

Answer 6

You wouldn't want to try and move a trailer up an incline with the MT70881. The dolly itself would be fine but you would most likely not be able to pull that heavy of a trailer up an incline. And then if you somehow did get it going up the…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Can the Trailer Valet XL Trailer Dolly be Used on Grass

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching