Can Curt Echo Mobile Trailer Brake Controller be Used with Hydrastar Actuator
Updated 05/24/2020 | Published 06/06/2019
Products Featured in This Question
Question:
is this actuator compatible with the curt wireless brake controller?
asked by: Steven S
0
Expert Reply:
Yes, the Curt Echo Mobile brake controller # C51180 is compatible with electric over hydraulic brake actuators like the HydraStar part # HBA16-252-82 you referenced so these two would work great together. The Hydrastar actuators are the most reliable and fastest reacting so they are what we recommend the highest.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Hydrastar Electric Over Hydraulic Actuator Kit for Disc Brakes - 1,600 psi
- Brake Actuator
- Electric-Hydraulic Brake Actuator
- Boat Trailer
- Travel Trailer
- Disc Brakes
- Hydrastar
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Hydraulic Brake Kit - Uni-Servo - Free Backing - Dacromet - 12" - Left/Right Hand - 5.2K to 7K
- Search Results: trailer breakaway switch
- Search Results: trailer breakaway kit
- Shop: Dexter Bearing Kit - Bearings 15123/25580, Races 15245,25520, Seal 10-36
- Shop: Replacement Trailer Wheel Bearing Kit, Bearings 15123/ 25580, Races 15245/25520 Races, 10-36 Seal
- Shop: Hydrastar Disc Brake Kit w/ Actuator for Tandem Axle Trailers - Slip On Rotor - 5 on 4-1/2 - 3.5K
- Shop: DeeMaxx Disc Brake Kit - 12" Rotor - 6 on 5-1/2 - Maxx Coating - 6,000 lbs
- Shop: Demco Hydraulic Trailer Brakes - Free Backing - Galvanized - Left/Right - 10" - 3.5K
- Shop: Demco Hydraulic Trailer Brakes - Uni-Servo - Galvanized - 12" - Left/Right Hand Assemblies - 7K
- Q&A: Troubleshooting Overheating Hubs on a Trailer With New Bearings and Grease
- Q&A: Replacement Brake Assemblies for Boat Trailer Hub with 6 Lug Bolt Pattern
- Shop: Trailer Hitch
- Search Results: equalizer hitch parts
- Shop: Lift Assist
- Q&A: Will the Autowbrake Electric Brake Controller Work With EOH Brakes
- Search Results: trailer ramp assist spring
- Search Results: load assist trailer ramps
- Search Results: gorilla~lift lift supports
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Search Results: trailer hitch
- Shop: Trailer Wiring
- Video: The Low-Down on the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Suspension Enhancement
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
Explore Expert Info
![Our Expert]()
on Brake Actuator
on Brake Actuator
Clint P.
5/18/2020
I have the Curt Echo Mobile brake controller C51180 installed with the HydraStar 1600 PSI marine plug and play system and it works just fine as long as I do not have the running lights turned on or use the blinkers. If you turn on either the running lights or blinkers it activates the HydraStar actuator. Seems like anytime the tail lights or reverse lights are on it activates the HydraStar actuator. Any ideas why there would be any power bleed-off that would cause the HydraStar actuator to activate? I am OK without using my blinkers but at dusk or night I must run my running lights. Hope I was able to explain the issue I am having and look forward to your response.