Will the SilverBack RV Sewer Hose Kit Fit In a 4 x 4 Square Bumper

Question

Question:

Can this hose with fittings be stored in standard RV 4inch square bumper?

asked by: Frank G

1

Helpful Expert Reply:

Yes, you can store the SilverBack RV Sewer Hose Kit w/ Swivel Fittings part # D04-0650 in a standard 4" x 4" bumper. However, you will need to remove the 90 degree elbow fitting most likely and store it somewhere else in order to do so. Please note we also offer extensions for this sewer hose as well, part # D04-0602 for 2' long or part # D04-0605 for 5' long.

expert reply by: Conner L

1

Answer 1

I hear you on the frustratingly slow electric jacks Eric. The quickest one we have is the Phoenix Electric Trailer Jack item #UF38-944040. With a 1,000 lbs tongue weight, this jack extends 6" in 10 seconds and retracts 6" in 8.6 seconds.…

view full answer...

Answer 2

Hey Raymond, since the 5k rated etrailer jack part #e55ZV is rated higher than the 3.5k option you also mentioned it will work a little bit quicker since it won't be working quite as hard. With that said it's not a fast jack by any means. It…

view full answer...

Answer 3

On the Ultra-Fab A-frame trailer jack #UF38-944037 from the top of the mounting plate to the bottom of the gear box it is 14-7/8 inches. I have included a picture showing several external measurements for this jack.

view full answer...

Answer 4

No, the Dominator RV Sewer #D04-0250 hose collapses for storage, but will not fit in a 4' bumper storage. The fittings are 4 1/8 inch in diameter. You may want to go with the Valterra RV Sewer Hose Carrier Adjustable to 34" to 60"…

view full answer...

Answer 5

Hey Joe! Did your old jack quit on you? Your 2019 Lance 1985 travel trailer will have the standard A-frame 3" bolt pattern on the tongue. Both the Lippert Smart Jack Electric Trailer Jack #LC643589 and Phoenix Electric Trailer Jack #UF38-944040…

view full answer...

Answer 6

Hi Tom, I have two options to replace the electric tongue jack on your Jayco Whitehawk: Option 1: Electric Jack w/ Footplate #EJ-3520-BBX. This jack is going to be your no-frills 'get the job done' style jack. It has a 3,500lb capacity and…

view full answer...

Answer 7

The Camco RhinoEXTREME RV Sewer Hose #CAM39861 is one of the highest rated waste hoses on the market in terms of durability so it's a bit of shock that yours only lasted a year. The Dominator RV Sewer Hose #D04-0250 and Lippert Waste Master RV…

view full answer...

Answer 8

You should never use an impact drill to raise or lower a jack since it would hammer as it drills and most likely damaged the internal components of the jack making it harder to manually raise and lower it. Ultra-Fab has stated that the Phoenix…

view full answer...

Answer 9

The Lippert electric trailer jack 181794 was replaced by the Lippert trailer jack part #LC285318 with a 3,500 lbs capacity and 18 inches of lift. The Lippert jack measures 21-1/2 inches from the bottom of the mounting bracket to the very top of the…

view full answer...

Answer 10

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Will the SilverBack RV Sewer Hose Kit Fit In a 4 x 4 Square Bumper

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching