Troubleshooting RV Auto-Leveling System Whose Jacks Do Not Extend
Updated 08/17/2020 | Published 05/21/2019 >
Products Featured in This Question
Question:
LCI level up not down. I manually solved the issue temporarily but would love the CORRECT fix if anyone can assist. System says it’s auto leveling but when it thinks it’s done and says jacks down, the two rear passenger side jacks are not touching the ground. Any ideas? I think the control pad may be bad...
asked by: Jim
Expert Reply:
The part # LC304136 that you referenced is the replacement module for the Lippert Ground Control 3.0 electric leveling system # LC358590 with 4 jacks. Since it sounds like you have a setup with 6 jacks and two of them show similar behavior my Lippert contact thinks you may have the Level Up hydraulic jack system. In this system the hydraulic pump that operates the jacks feeds the two rear jacks from the same hydraulic line. This would explain why two jacks both got hung up before hitting the ground.
The usual cause for this is a weak power source. If the batteries feeding the hydraulic pump are not able to deliver the full required voltage the circuit breaker for the pump will trip to prevent the under-voltage condition from overheating the pump motor. This condition would cause the system to be able to only partially level the 6 jacks. You can check the actual output voltage reaching the pump with a tester like # PT89ZR and/or put an AC shore-power battery charger like # CTEK56353 on the RV. If the issue persists with full power to the pump you will want to contact Lippert tech support. I have sent their contact information to you separately.
Product Page this Question was Asked From
Replacement Control Module for Lippert Ground Control 3.0 Electric Leveling System
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Controllers
- Control Module
- Lippert
more information >
Continue Researching
- Shop: Replacement Control Module for Lippert Ground Control 3.0 Electric Leveling System
- Shop: Replacement Wiring Harness for Lippert Ground Control 3.0 RV Landing Gear - Front Driver's Side
- Shop: Replacement Control Panel for Lippert Ground Control 3.0 and Travel Trailer RV Leveling System
- Video: Lippert Ground Control 3.0 Electric Leveling System Replacement Control Module Review
- Video: Review of Lippert Replacement Ground Control 3.0 Electric Leveling System Control Module - LC304136
- Shop: C-800 Replacement Klauber Motor for Standard Lippert Electric Stabilizer Jacks
- Search Results: stabilizer jacks camper jacks
- Q&A: Troubleshooting Error Message on Panel for Lippert Ground Control Leveling System
- Q&A: Lippert Ground Control 3.0 Will Not Retract
- Q&A: How To Test for Bad Controller on Lippert Ground Control 3.0 Electric Leveling System
- Q&A: Lippert Ground Control Auto Level Issues
- Q&A: Troubleshooting Left Side of Lippert Ground Control Leveling System that Doesn't Work
- Q&A: Troubleshooting Lippert Ground Control 3.0 Experiencing Retraction and Power Issues
- Q&A: Left Side Jack on Ground Control 3.0 Is Not Responding
- Article: Trailer Wiring Diagrams
- Search Results: trailer hitch
- Shop: Trailer Hitch
- Video: Furrion Chill Cube RV Air Conditioner Review and Installation - Travel Trailer Edition
- Shop: Power Mountain Tallboy Off-Road Bottle Jack - 8-1/2" to 37-3/4" Lift - 6 Tons
- Video: Replacement Dome Assembly for Ventline Ventadome Trailer Roof Vent Spec Review
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Search Results: rv air conditioners
- Shop: etrailer Electric Trailer Brakes - Self-Adjusting - 12" - Left/Right Hand - 5.2K to 7K
- Shop: Trailer Wiring
- Search Results: trailer tires and wheels
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Video: Review of GE Appliances RV Air Conditioners - 15000 Btu White Low Profile Ducted Heat Pump - GE38RR
- Shop: Suspension Enhancement
- Search Results: trailer brakes


Dennis G.
8/6/2020
my ultra leveling system will not go down or up, the solenoid sounds like its clicking but the motor is not running