Left Side Jack on Ground Control 3.0 Is Not Responding

Question

Question:

We have a front left jack that won’t respond, up or down. Continue to get a fault message on the touch screen. We have checked the fuses and all are good. Before I ordered a motor I switched the pig tails left for right and now get a right jack fault. Could this be an issue with the control board or something else? Don’t want to purchase an item if not needed. 2019 coachman chaparral 298 rls Thank you

asked by: Richard C

0

Expert Reply:

Since the left side jack of your Lippert Ground Control 3.0 is not responding, and you have checked the fuses, since you mentioned switching the harnesses around and the issue then occurred on the other side I would say that is the issue over a faulty Control Module # LC304136.

It sounds like the harness for the jack is faulty, and the harness can be replaced with the Replacement Wiring Harness for Lippert Ground Control 3.0 - Left Side Landing Gear # LC307490.

expert reply by: Kyle S

0

Answer 1

The part #LC304136 that you referenced is the replacement module for the Lippert Ground Control 3.0 electric leveling system #LC358590 with 4 jacks. Since it sounds like you have a setup with 6 jacks and two of them show similar behavior my Lippert…

view full answer...

Answer 2

Sounds like you have a Lippert Ground Control setup installed on your motorhome. Typically with issues like this Lippert recommends unplugging the control panel which should look like #LC175225 for a few seconds to let it reset and then plug it back…

view full answer...

Answer 3

I spoke with my contact at Lippert regarding the error message issue you are having with your Ground Control Leveling System. He says it sounds like the controller may have gone bad. To check this you can cut power to the controller and just do a…

view full answer...

Answer 4

It does sound like the Control Module #LC304136 for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System #LC675817 is the issue on your Salem Hemisphere. Since you have confirmed all the fuses and voltages are correct on the system…

view full answer...

Answer 5

In order to test the controller on the Lippert Ground Control 3.0 Electric Leveling System you'll first need to obtain a multimeter. Once you have this then you will need to use the ground probe and place that on the green wire coming from the…

view full answer...

Answer 6

If you have reset the system and they are still not retracting, you will need to check a few things. First will be the fuses. If one or more of these have failed, it can cause the system to not function properly. Next will be ground connections. A…

view full answer...

Answer 7

The part you are referring to is a circuit breaker, not a relay. In order to test the circuit breaker all you need to do is probe the blue wire that feeds this and then the red wire which is the output. If you get 12 volts on the red output wire…

view full answer...

Answer 8

Yes, the Replacement C-Jack for Lippert Electric Ground Control TT #LC404488 can be operated manually if a switch happens to go bad or you lose power. To operate manually, you'll first need to disconnect the battery before continuing. Next,…

view full answer...

Answer 9

There are a few possible reasons as to why you can't get your Lippert Electric Jack #LC285318 (this is essentially the current version of your 181794) to extend. While possible, I doubt the leg as simply been jammed due to a lack of lubrication.…

view full answer...

Answer 10

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

Hey Tim welcome back! Your ARH15AACBL2 GE AC unit has the old 410a refrigerant in it so the GE Appliances item #GE64FR you were looking at isn't going to work as a replacement. The EPA mandated R32 refrigerant has been used in all new AC's…

view full answer...

Left Side Jack on Ground Control 3.0 Is Not Responding

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching