How to Remove Screen on Ventline Ventadome Roof Vent for Cleaning

Question

Question:

how do i remove the screen in order to remove all the dirt trapped on the screen. Can it be removed from inside the camper since I have a Max Air vent cover up installed on the roof.

asked by: Russ P

0

Expert Reply:

To remove the screen from the Ventline Ventadome # V2094SP-30 you simply need to pull down on it from inside the trailer so there is no need to get on top of your trailer roof. If you check out the attached review video you can see this done.

expert reply by: Jon G

0

Answer 1

I spoke with my contact at Ventline regarding your E-Z Lift Ventadome Trailer Roof Vent #V3094-603-00C. To remove the screen, you will just need to release the 8 tabs by pressing a small screwdriver to them. You can release one tab at a time. Once…

view full answer...

Answer 2

To remove the screen on the Ventline Vanair Trailer Roof Vent #VP-543SP you will first need to remove the screw from either side of the handle, remove the handle, and then remove the screws that hold the vent in place. Be careful when you lower the…

view full answer...

Answer 3

We have a video that outlines the procedure for removing the roof vent screen, click on the provided link to view the video. The procedure will involve removing the interior trim as well as the knob or crank, and then the screen can be removed by…

view full answer...

Answer 4

I believe that the only way to go about this, if you cannot get a tool in that space, is to do exactly like you said and go in from the outside. If you do not have the handle pulled all the way down, that could be the problem as well. I would assume…

view full answer...

Answer 5

If you check out the video I attached to this page you'll see a general guide for removing the screen of a roof vent in the the first minute of the video. This process is basically standard amoung trailer roof vents so this process will be…

view full answer...

Answer 6

You can replace the screen on Ventline Trailer Roof Vent in a few easy steps. Make sure that the screws that hold on the handle are exposed. Remove them and then the handle. Next unscrew the small black piece that holds the switch to the screen…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 10

Hi Chuck! The MORryde RV Cargo Slide Tray - 72" x 26" - 1 Way Slide - 60 Percent Extension - 800 lbs #MR67FR sits 1.6 inches above the floor you mount it on. If you want or need it to be a bit higher off the floor, you can also grab the…

view full answer...

How to Remove Screen on Ventline Ventadome Roof Vent for Cleaning

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching