Where Does Hitch Lock Install on Equal-i-zer Weight Distribution System

Question

Question:

How do you attach these locks to the hitch

asked by: Jackie

0

Expert Reply:

The hitch locks like the # e98880 that you referenced are for locking the shank of the weight distribution system like part # EQ37100ET to the hitch it's installed in. I attached a picture that points out where the lock installs as well as a review video for the lock for you to check out too.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The Equal-i-zer Weight Distribution System #EQ37100ET fits 2-inch hitches so you can use one of the 2-inch hitch locks shown on the linked page. The etrailer.com #e98880 is a flush design that keeps the center span of the pin inside the receiver -…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 5

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 6

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 7

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Hey Gina, thanks for reaching out. Yes, the Air Lift 1000 Air Helper Springs #AL63WQ will fit your 2025 Nissan Pathfinder Rock Creek. They're designed to install inside the factory rear coil springs and are a great option for helping reduce…

view full answer...

Answer 10

Thanks for reaching out, Dennis. Yes, if you purchase the Yakima LockNLoad Platform Roof Tray #Y05044 along with the Crossbar Clamps for Yakima LockNLoad Platform Rack #Y05039, you'll receive all of the hardware needed to assemble the tray and…

view full answer...

Answer 11

The best brake controller option to go with is one that activates the brakes proportionally instead of time delayed. A proportional brake controller will activate the trailer brakes at the same time and with the same intensity as the tow vehicle…

view full answer...

Answer 12

The Replacement Mounting Bracket for Yakima SlimShady Roll-Out Awning #8880736 will work with the Yakima LockNLoad and your CVT Awning, but you will need to modify the brackets a little. I'm not quite sure what modifications are required but we…

view full answer...

Where Does Hitch Lock Install on Equal-i-zer Weight Distribution System

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching