Correct Replacement Cradles for Yakima SwingDaddy Bike Rack

Question

Question:

Sorry - digging further on your website and learning that my swing daddy is likely older than 2017. Modified question: Is this the appropriate replacement anti swing cradle for the 2015-16 era swing daddy Y02464? My swing daddy does not have the extra-cushion straps and has grey release tabs for the straps. Thank you!

asked by: Doug

0

Expert Reply:

Thanks so much for the photos, they were very helpful.

To replace all four cradles, what you need is two of the Replacement SuperCush Anti-Sway Cradle and ZipStrips # 8880598 (which has the upper and lower ZipStrip) along with two of the Replacement SuperCush Cradle and ZipStrip # 8880597.

expert reply by: Kyle S

0

click to enlarge

Answer 1

Good news, there are other cradles sized for 1 inch arm tubes. You could swap out the cradles on the Rola for Thule Stay-Put cradle and strap, #853-7887 and #852-3006-001. If you wanted the added security of an anti-sway the Stay-Put has that…

view full answer...

Answer 2

Hey Matias, If you'd like to send in some pictures of your Yakima bike rack I'd be happy to take a look and see if there's any replacement parts still available.

view full answer...

Answer 3

The correct kit for the older SwingDaddy #Y02422 is actually the part #Y8890185.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 11

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 12

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Correct Replacement Cradles for Yakima SwingDaddy Bike Rack

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching