Wiring Switch of Lippert Components High-Speed Power Stabilizer Jack

Updated 04/30/2019 | Published 04/27/2019

Products Featured in This Question

Replacement Electric Jack Waterproof Switch with Harness for Lippert High Speed Stabilizer Jacks

(150)

$81.73

10 Gauge Wire - Blue Primary - Per Foot

(109)

$1.87

Question:

I just purchased a switch from you for my trailer jack. The wires came off before i was able to mark. I have a switch with four prongs. I have 3 black wires and 1 red wire. Can u help on where they go

asked by: Paul M

Expert Reply:

I was unable to find your order number but I assume you have the Replacement Electric Jack Switch with Harness # LC387874 for your Lippert Components High-Speed Power Stabilizer Jack # LC298707 as this jack will have black and red wires that the switch connects to. To wire it you can follow the diagram I added from the jack manual.

The black wire of the switch goes to the negative battery terminal, the red wire goes to the positive terminal through the jack's 20 amp breaker, the yellow wire (retract) will connect to the black motor wire and the blue wire (extend) will connect to the red motor wire.

Keep in mind the red and black wires on the switch will require at least 10 gauge wiring such as # 10-1-1.

expert reply by: Kyle S