Is the Fulton Single Axle Fender with Top Step Compatible with Pre-Existing Fixed Brackets?
Question:
mounting to existing trailer brackets My trailer uses fenders that bolt to a fixed trailer step in the front and a welded on bracket in the rear like what Magic Tilt uses with their fenders for 13inch tires. Can I drill the ABS fenders you sell to mount to my pre existing fixed brackets?
asked by: JIM B
Helpful Expert Reply:
The Fulton Single Axle Trailer Fender with Top Step - Silver Plastic - 13" Wheels - Qty 1 # F008563 can absolutely be drilled to fit the pre-existing fixed brackets on your trailer frame. The capacity of the Polyethylene step will impact the 300 lb rated capacity it was originally tested for.
Product Page this Question was Asked From
Fulton Single Axle Trailer Fender with Top Step - Silver Plastic - 13" Wheels - Qty 1
- Trailer Fenders
- Top Step
- 13 Inch Wheels
- 9 Inch Wide
- 30 Inch Long
- Plastic
- Bolt-On
- For Single-Axle Trailers
- Silver
- Fulton
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How to Determine the Capacity of Trailer Leaf Springs and How to Raise the Coupler Height
- Q&A: Trailer Modifications and 8 inch to 12 or 13 inch Tire and Wheel Upgrade Recommendations
- Q&A: Wheel and Tire Recommendation For Jet Ski Trailer with Tire Size ST175/80R13
- Q&A: Trailer Fender Installation Clearance and Mounting Project
- Q&A: Can a 5.30-12 Size Tire be Replaced with a ST145/R12 Size Tire
- Q&A: Drum Brake Replacement Assemblies for Use with Titan Actuator
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Choosing Replacement Fender for Tracker Marine Boat Trailer
- Article: Trailer Tire Sizing
- Article: Where to Position the Trailer Axle?
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Best Boat Accessories