Can 2-5/8 inch Shackles Get Replaced with Replacement Shackle Link # 018-026-05

Question

Question:

I am looking for upgraded wet shackle kit for triple axle toy hauler with 6k axles. The current shackle length is 2 5/8. Can I use these shackles as a replacement?

asked by: Michael H

0

Expert Reply:

Going with a slightly shorter shackle like the part # 018-026-05 would not be an issue. The shackles will angle slightly flatter than the longer current shackles you have now but they'll still work fine.

expert reply by: Jameson C

0

Answer 1

In order for your trailer suspension to function properly you will want the angle of the shackle strap to be towards the axle so that as the leaf spring compresses and expands it will have somewhere it can go. Otherwise, you will not get the optimum…

view full answer...

Answer 2

Thank you for the pictures. The shackles should always be pointing up at about a 45 degree angle towards the axle. There is not a specific angle set in stone, but they should should make a "W" shape at all times. They appear to be…

view full answer...

Answer 3

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

view full answer...

Answer 4

Hey Jared, the Equa-Flex cushioned equalizers part #LC145546 that you referenced are normally used on 35 inch wheelbases.

view full answer...

Answer 5

Hello Robert, Thank you so much for attaching the pictures, they’re always so helpful. In the first photo, it looks like your shackle straps are sitting a bit too vertically. That’s not a major issue, but since you’ll be replacing some suspension…

view full answer...

Answer 6

Hello George, thanks for reaching out. When replacing equalizers and shackles, it is critical that the replacement parts are identical in size to the stock components. There is a small amount of tolerance, like maybe 1/2" or less, but any…

view full answer...

Answer 7

The Keystone Carbon 417 should have a 35" axle spread which can be confirmed by measuring from the center of each axle. In which case, we have options from both Dexter and MORryde. The MORryde Rubber Equalizers for Triple Axle Trailers part…

view full answer...

Answer 8

For a triple axle trailer with 6k rated axles the correct Dexter EZ Flex is the part #K71-656-00. The #K71-657-00 would be for 8k axles. I attached an install video for this kit for you to check out as well.

view full answer...

Answer 9

The Dexter E-Z Flex Triple Axle Suspension Kit #K71-657-00 referenced in your question is designed for triple axle trailers and includes equalizers that measure 7-3/4 inches long. If your Weekend Warrior has 3 axles and the equalizer length matches…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

view full answer...

Can 2-5/8 inch Shackles Get Replaced with Replacement Shackle Link # 018-026-05

Product Page this Question was Asked From

Continue Researching