Color Temperature of Opti-Brite LED RV Dome Light # ILL29CFB

Question

Question:

Your video was very helpful. Do you have any idea what the color wavelength of the LEDs are on this model ceiling light? Thanks again!

asked by: Terry

1

Helpful Expert Reply:

The Opti-Brite LED RV Dome Light # ILL29CFB has the typical bluish hue found on LED lights which would fall in the 6,000k range as far as temperature. Not purely white but just a little blue.

The picture I attached shows you what color it exactly is.

expert reply by: Jameson C

1

click to enlarge

Answer 1

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 2

The easiest thing to use/install is the NightMinder RV Task Light #NM-Motion-011. This is a battery powered light that uses 3 AAA batteries (not included). All you need to do is get rechargeable batteries to avoid purchasing batteries constantly. It…

view full answer...

Answer 3

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 10

A trailer that is over 80 inches wide is required by DOT regulations to have rear clearance lights. An over 80 inch taillight kit, like part #TL16RK, will have the side clearance light built into it. An under 80 inch taillight does not have the…

view full answer...

Answer 11

Hey Gwen! The distance from the center of the mounting hole to the bottom of the Trailer Valet JX Trailer Jack #TV35FR when fully retracted is 13.44". If you’re measuring from the bottom of the pipe mount instead of the center of the hole, that…

view full answer...

Color Temperature of Opti-Brite LED RV Dome Light # ILL29CFB

Product Page this Question was Asked From

Continue Researching