How to Determine the Correct Slipper Spring for 6,000 lb Axle

Published 02/20/2019

Products Featured in This Question

5-Leaf Slipper Spring w/ Hook End for 6,000-lb Trailer Axles - 27" Long

(263)

$71.28

Spring-Eye Bolt with Locknut for Slipper Springs - 3-1/2" Long

(559)

$15.66

Question:

6 k dexter axles 15 inch tires and rims e rated tires rims 6 hole rims slipper springs need three for my 34 ft pj trailer car / equipment trailer 83 inches between fenders Thanks

asked by: Douglas S

Expert Reply:

The slipper spring we carry for 6,000 lb axles is the 5-Leaf Slipper Spring w/ Hook End # e67SR.

To figure out if this spring is going to work for you there is a measurement you will need to take. If you look at the accompanying diagram you can see that "C" is 27 inches. This is the length from the center of the eye to the end of the spring with the slipper; you can measure your current slipper spring to see if you have a similar measurement, keeping in mind that the current spring may have elongated or sagged so it may not be exactly 27 inches, but it should be close.

It is important to replace all your springs at the same time in order to keep the support of the trailer even throughout. It is also a good idea to use new bolts with a new spring as your older bolts are likely to have been subjected to wear; for replacement bolts you can use Spring-Eye Bolt with Locknut for Slipper Springs # 166079.

expert reply by: Kyle S