Replacement Legs and Hardware for Older Thule CapRac 29200

Question

Question:

hey so i reached out a few days about a ladder rack part and i see that since then it has been added # TH8527646001. but before i order id like to know if the part comes with the mounting brackets or is it just the feet to the rack. also is this just one leg or two or all four?

asked by: Mujaab

0

Expert Reply:

For the mounting feet for the older style CapRac 29200 (not the newer CapRac part # TH29200XT) you need the replacement feet part # TH8527646001.

If you only have the crossbars then you likely need the hardware as well. The hardware can be found with Bag 1 # THHD80935A and Bag 2 # THHD80936 which I confirmed with my contact at Thule is all you'd need to have the complete CapRac setup.

expert reply by: Jon G

0

Mujaab

2/20/2019

hey so i reached out a few days about a ladder rack part and i see that since then it has been added # TH8527646001. but before i order id like to know if the part comes with the mounting brackets or is it just the feet to the rack. also is this just one leg or two or all four?

Jon G.

2/20/2019

I spoke with my contact at Thule who said that the mounting feet come in a quantity of 1 so you will want to order 4 of them. The hardware bags that I referenced above include the mounting brackets that you need as well as any bolts or washers. My contact at Thule confirmed this too.

Answer 1

Though we do not have a custom fit option for your two Freightliner trucks, I may still have something that will work. I will say that both of these will depend on how wide the frame is where these would attach. The more heavy duty option will be the…

view full answer...

Answer 2

The Buyers Products Fabricators Hitch Plates like part #3371809042 are not given a weight capacity by the manufacturer. This is because the weight capacity will largely be dependent on how securely it is mounted. The highest rated pintle hook we…

view full answer...

Answer 3

Ram gooseneck coupler #GCPN-25008 has set screws and a 7/8" diameter pin. The set screws are 3/4"-10 x 2-1/2". It is recommended to use a large crescent wrench to adjust the set screws since they have a square head instead of a hex…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 7

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Replacement Legs and Hardware for Older Thule CapRac 29200

Product Page this Question was Asked From

Continue Researching