Recommended TracRac TracOne Ladder Rack Tool Box Mounts for 2018 Ford F-150

Question

Question:

Still don’t see installation guide. Also, the picture you attached has 2 flat brackets with holes drilled in them for 1 side of the ladder rack. The product itself, when purchasing, only comes shows it come with 2? This is why I am asking for installation guide. I’d like to see if you only need one per side or what.

asked by: Mason K

0

Expert Reply:

For your 2018 Ford F-150 the TracOne ladder rack will use the Toolbox Mount Kit for Thule TracRac TracONE Truck Bed Ladder Racks # TH41000 to give you the compatibility you are seeking by providing threaded holes for your toolbox instead of using J hooks.

I've attached our article on this fit and have also attached a photo to assist.

expert reply by: Jason S

0

click to enlarge

Mason

2/7/2019

Still don’t see installation guide. Also, the picture you attached has 2 flat brackets with holes drilled in them for 1 side of the ladder rack. The product itself, when purchasing, only comes shows it come with 2? This is why I am asking for installation guide. I’d like to see if you only need one per side or what.

Jason S.

2/7/2019

I tried to find the installation for you on the TracOne, but found the same kit on the G2 model instruction sheet to assist. You will notice the rounded shims and plates are only needed if the depth of your toolbox warrants use from extending behind the platform base to be used as a separate clamp from the ladder rack. That is why there are only two metal brackets and 2 rubber shims along with two bolts and under rail clamps.

Answer 1

I believe you are talking about the Thule SnowPack #TH7324 or #TH7324B. You are correct that you remove the rubber piece and then lift up the plastic handle and turn it counter-clockwise to get it to release from the T-Bolts or the clamping feet. I…

view full answer...

Answer 2

I have attached a parts breakdown of the Thule TracRac TracONE Ladder Rack part #TH27000XT-EX. Can you please tell me exactly which part(s) you are referring to? If you just need a single upright post then you can use the Replacement Modular Upright…

view full answer...

Answer 3

The Replacement Clamp for Toolbox Mount Kit for Thule TracRac TracONE Truck Bed Ladder Racks #THFX-27068 includes only one clamp, as shown in the product photos. The short 3/8"-16X.625" BCHS can be purchased as replacement part #TAHD-27051.…

view full answer...

Answer 4

According to my TracRac representative, the clamps that hold the front crossbar of the rack to the top of the bed side rail will extend into the interior of the bed by 1-1/4 inches per side, for a total of about 2-1/2 inches. If the width of the…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Recommended TracRac TracOne Ladder Rack Tool Box Mounts for 2018 Ford F-150

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching