How Is Connection Made Between Wiring and Pins of 2-Pole Trailer Wiring Connector # PK12800
Published 01/16/2019
Question:
Your videos do not show the actual Wiring of a pollak pk12800 2pole plug. The Instructions were not available on the website either. How is the wire best connected to the interior of the plug on the trailer side. Should it be welded/soldered into the end of the copper fitting?? Or is there a certain size crimp connector that is crimped on the end of the wires and then inserted into the backside of the brass fittings?
asked by: Chris
Expert Reply:
You'll need to solder the wiring to the pins that are in the 2-Pole Trailer Wiring Connector # pk12800. Basically you take off the black front section by removing the set screw and then run the wires through the back of the connector and solder them to the pins and reassemble.
Product Page this Question was Asked From
2-Pole Trailer Wiring Connector - Trailer Side
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 2 Pole
- Plug Only
- Pollak
more information >
Continue Researching
- Shop: Trailer Wiring
- Search Results: relay switch
- Search Results: circuit breaker
- Search Results: ratchet straps
- Search Results: e track
- Shop: Replacement 12V Solenoid Starter for Meyer Snowplows - Motor Solenoid - 4 Post - Qty 1
- Shop: Buyers Products Circuit Breaker w Manual Push-to-Trip Reset - Surface Mount - 200 Amp
- Shop: 2-Pole Socket Connector - Vehicle Side
- Shop: 2-Pole Trailer Wiring Connector - Trailer Side
- Video: All You Need to Know About the 2-Pole Trailer Wiring Connector
- Video: The Low-Down on the 2-Pole Socket Connector
- Shop: Kenda Karrier KR53 ST225/75R15 Radial Trailer Tire with 15" Black Mod Wheel - 6 on 5-1/2
- Shop: Starter Solenoid - SPST - 12 Volt - 100 Amp - Continuous Duty - Grounded
- Shop: Buyers Products 2-Way Die-Cast Zinc Trailer Connector - Truck Side - Horizontal Pin Arrangement
- Q&A: Recommended Electric Winch With Remote for Boat Trailer With 8,000 Pound Grady White Gulfstream
- Q&A: Do 7-Way Trailer Connectors have Amp Ratings for Pins or the Whole Socket
- Q&A: Winch Battery Recommendation for 3000-lb Winch with 170 Amp Draw
- Q&A: Methods for Powering Electric Winches
- Article: Most Popular Wheel Bearings
- Q&A: Leaf Spring Bushings Closest to 1-1/4 Inch Outer Diameter
- Q&A: How to Wire Pollak 2-Pole Trailer Wiring Connector # PK12800
- Q&A: Peterson 2-Wire Amber Clearance/Side Marker Lights With Chrome Mounting Bracket/Bexel.
- Article: How to Dump Black and Gray RV Waste Tanks
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Curt Echo Full Review
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)