Replacement for Fulton 12K Magnum Series HD Jack

Updated 11/05/2018 | Published 11/03/2018

Question:

I have a 2003 Kiefer Genesis 4 horse trailer and need to replace the Fulton 12,000# Magnum Series HD jack-stand. It is center mounted on the trailer see picture. I am not sure if you provide the connector pipe between the stand and the crank that allows the access to raising and lowering the stand from the side of the trailer rather than under it., but I need all the pieces , picture 2. Can you provide the ordering information so I can order and receive all I need to replace the current stand? Thank you

asked by: Peter

Expert Reply:

The photos you attached did not come through but in order to replace your Fulton 12K Magnum Series HD Jack, I recommend using the Bulldog Square Jack part # BD182701 which has a 12,500 lbs capacity and offers up to 12-1/2" of lift. Unfortunately, Bulldog does not offer the extension rod that will allow you to operate the jack from the side of the trailer as they will vary depending on the trailer. I am certain you would be able to find everything you need to make one at a local hardware store though. Once you find an extension rod that will work for you, you can then use the Bulldog Sidewind Jack Crank Assembly part # BD015181 to operate the jack from the side of the trailer.

expert reply by: Conner L