Troubleshooting Codes for Redarc Tow-Pro Elite Brake Controller Installed in 2018 Cadillac Escalade
Updated 09/19/2018 | Published 09/18/2018 >
Question:
I used the factory wire harness for the brake control but the brake signal flashes
asked by: Carly S
Expert Reply:
It sounds like you have installed your Redarc Tow-Pro Elite trailer brake controller # RED44FR using the custom GM wiring adapter # 3016-S. This is the correct harness for the 2018 Cadillac Escalade with factory 7-way connector.
An error code from ANY trailer brake controller most often is a result of a connectivity issue like a loose or dirty trailer plug (or vehicle socket). For the Tow-Pro Elite a flashing error code may remain until you unplug the trailer and wait at least a minute or two for the unit to reset.
Redarc uses specific color codes to indicate the specific problem. If you refer to pages 17 and 18 of the linked instructions for the controller in the photo that I included you will see the specific color codes that will tell you what the most likely issue is.
Product Page this Question was Asked From
Redarc Tow-Pro Elite Brake Controller - Dash Knob - Off-Road Mode - Up to 3 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Splice-In
- Dash-Mounted Knob
- Behind-Dash
- Up to 3 Axles
- Indicator Lights
- Single Trailer Only
- Redarc
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Brake Controller Installation on my 2017 Audi Q7
- Q&A: Comparing the Curt Spectrum Brake Controller and Redarc Tow-Pro Elite for a 2016 Audi Q5
- Search Results: accessories and parts
- Search Results: tee
- Shop: Tuson Trailer Sway Control System - Electronic - Up to 4 Axles
- Shop: Suspension Enhancement
- Video: What to Know About the Air Lift Union Tee for 1/4" Air Lines
- Video: Breaking Down the Air Lift Union Tee for 1/4" Air Lines
- Shop: Brake Controller
- Shop: Trailer Wiring
- Q&A: Brake Controller Recommendation for a 2023 Mazda CX-50 with OEM 7-Way Harness
- Article: Brake Controller Installation: Starting from Scratch
- Search Results: auxiliary lights
- Search Results: 7 pin to 4 pin
- Search Results: wire loom
- Search Results: ptw80647
- Search Results: 7 pin tester
- Shop: Trailer Hitch
- Video: Hands-On with the Curt Echo Under-Dash Bluetooth Brake Controller w/ Custom Harness
- Video: Redarc Tow-Pro Elite Trailer Brake Controller Installation - 2022 Nissan Frontier
- Video: Redarc Tow-Pro Elite Trailer Brake Controller Review
- Video: The Low-Down on the Curt Auxiliary LED Indicator Lights
- Video: Pollak 7 Pole to 4 Way Connector Adapter Feature Review
- Shop: Curt Discovery NEXT Trailer Brake Controller w/ Custom Harness - Up to 4 Axles - Time Delayed
- Shop: Curt Auxiliary LED Indicator Lights
- Shop: InfiniteRule Ball Mount Hitch Lock - Gen-Y Mega Duty 32K and Fastway Flash HD - 3/4" Pin
- Shop: Curt Custom Wiring Adapter for Trailer Brake Controllers - Dual Plug In
- Shop: Composite Trim Removal Tool Kit - 5 Piece
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Q&A: What is the Difference Between a Class II and a Class III Hitch?



